Aviom AN-16-i User Manual
DATA SHEET
v. 2
Input Module
Product Highlights
The AN-16/i v.2 Input Module provides
sixteen channels of analog-to-digital
conversion as the head end for Aviom’s
Converts 16 line-level analog •
audio channels to a Pro16e
A-Net digital stream
industry standard personal mixing
system and modular digital snake
products. The module converts sixteen
line-level analog audio channels into
A-Net In for generating •
Pro16e A-Net for A360
uncompressed 24-bit, 48kHz digital
audio data.
Personal Mixers
The AN-16/i v.2 includes an A-Net®
16 balanced line-level inputs•
Input jack for connecting up to three
additional Pro16® Series input devices.
16 balanced line-level •
Thru jacks
The AN-16/i v.2 merges its analog
inputs with the incoming A-Net stream,
creating the expanded Pro16e digital
48kHz, 24-bit A/D converters•
audio stream utilized by Aviom’s A360
Personal Mixer. The digital audio data is
Four-position gain sensitivity •
output on standard Cat-5e cables.
switch per channel pair
Stereo Link per channel pair•
The AN-16/i v.2 front panel has eight
four-position input level/gain sensitivity
switches, stereo channel link switches
for every channel pair, and per-channel
AN-16/i v.2 INput Module SpecIfIcAtIoNS
Audio Inp uts 16, balance d line-level
TRS Inputs Tip: Audio +; Ring: Audio -; Sle eve: Ground
TRS Thru Tip: Audio +; Ring: Audio -; Sle eve: Ground
A/D Conver sion 48kHz, 24-bit
Input Level /
Gain Settings
Metering
Stereo Operation
Max.Input Level +22 dBu
Input Imp edance 17.8k ohms
Frequency Response 4Hz-22kHz +0.2dB/-3dB
THD +N < 0.003%
Crosstalk -90dB
Signal to Noise
(unweighted)
Bit Err or Rate (BER) 10
+22dBu, +4dBu, 0 dBu, -10dBV
4-posit ion gain switch, per ch annel pair
Two LEDs per channel;
green: Signal Present, red: Clip;
Stereo link, per channel pair;
Two-posit ion switch (Mono, St ere o)
90dB t ypical, A/D t o D/A;
Measured from AN-16/i v.2 to AN-16/o Output
Module
-12
signal present and clip LEDs. Digital
network connections on the rear panel
include one A-Net In jack and one A-Net
Out jack.
The rear panel of the AN-16/i v.2 also
features 16 analog audio inputs with balanced ¼” TRS jacks. An audio Thru jack
for each input allows the AN-16/i v.2
to be inserted seamlessly into an existing audio signal path. The AN-16/i v.2
can be used with any line-level analog
audio signal such as console direct outs,
inserts, or aux sends.
The AN-16/i v.2 is equally at home
with Aviom’s modular Pro16 digital
snake and audio distribution system
products, supporting a range of exible
congurations including: 16x0, 32x0,
48x0, 64x0, 16x16, 32x16, 32x32, and
48x16. All congurations support an
unlimited number of digital splits, with
no loss in audio quality.
Digital Output 1 A-Net Ou t; RJ45 conne ctor
Digit al Input 1 A-Net In; R J45 connect or
A-Net Pro16e Slots
A-Net Uses un shielded Cat-5e UTP (or bet ter) cable
A-Net Cable Length 400 feet (122 m)
Latency
Power Supply
Input Voltage
Output Voltage
Plug Siz e
Dimensions
Weigh t 6.8 lb. (3.08 kg)
Options
All Aviom products are designed and manufactured in the USA.
4-posit ion Slot Range switc h assigns the A-Net
output t o occupy Slot s 1-16, 17-32, 33-48, or 49-64
<0.880 msec (measur ed from analog inpu t to
analog o utput)
Exte rnal, DC, unive rsal switc hing type
100-240 volts, 50/60Hz, 30VA
18-24 VDC, 0.5 amp
2 mm
19” (482.6 mm) wide x 5.75” (146 mm) deep;
1U high
SB4 Syste m Bridge; used to combine up to four
A-Net str eams for transmission over one Cat-5e
cable
1157 Phoenixville Pike, Suite 201 • West Chester, PA 19380
Voice: +1 610.738.9005 • Fax: +1 610.738.9950 • www.Aviom.com
froNt pANel feAtureS
Stereo
channel
link
Audio Input 1-16
Input
Level
Audio Thru 1-16
+22dBu
+4dBu
0dBu
-10dBv
A-Net
A-Net In
A/D
converter
Signal Clip
A-Net In
Power
v.2
Mono Stereo
LED Meters: Signal and Clip ▪
Stereo Link switch ▪
Input Level/Gain Sensitivity: ▪
+22dBu, +4dBu, 0dBu, -10dBV
Power and A-Net In LEDs ▪
v. 2
Input Module
reAr pANel feAtureS
Line-level input jacks, ▪
balanced TRS
Line-level thru jacks ▪
A-Net In with 4-position Slot ▪
Range selector switch
A-Net Out ▪
DC power ▪
AN-16/i v.2 BLOCK DIAGRAM
ArcHItecturAl SpecIfIcAtIoN
The Aviom AN -16/i v.2 shall provide sixte en channels of line-level audio A/D
conversion. Channels shall be transmitted digitally onto an A-Net network. It shall
provide full-bandwidth, high-quality audio by employing the Aviom A-Net Pro16e
audio transmission protocol. It shall employ 24-bit A/D converters with a 48kHz
sampling rate.
It shall have a frequency response from 4Hz to 22kHz, +0/-0.3dB or better, with
total harmonic distortion no more than 0.003% at 1kHz with a +4dBu input signal.
Maximum input level without clipping shall be +22dBu. Input sensitivity shall be
selectable from a front-panel 4-position switch, with gain range settings of +22dBu,
+4dBu, 0 dBu, and -10dBV. Input impedance shall be 17.8k ohms.
Front panel features shall include LED indicators for Signal and Clip of each
channel. Each pair of channels shall have a Stereo Link switch. Front-panel power
and A-Net In LEDs shall be provided.
Aviom, A-Net , the A-Net icon, Pr o16, Pro16e, Pro 64, Virtual Dat a Cables, Net work MixBack ar e trademark s of Aviom, Inc. All othe r trademark s are the proper ty of their
respe ctive owners . ©2013 Aviom, Inc . All rights res erved. Infor mation subjec t to change withou t notice.
Rear panel features shall include a detachable DC power cord. The unit shall be
powered from an external universal power supply (input voltage 100 to 240 VAC;
output voltage 18-24 VDC, 0.5 amps). It shall be UL and CE listed.
The rear panel shall have RJ45 connectors for A-Net digital signal input and output
connections.
The AN-16/i v.2 model shall employ TRS input jacks for the sixteen line-level inputs.
Sixteen TRS jacks shall be provided for audio Thru connections.
Its dimensions shall be 19 inches wide, 9 inches deep, and 1U (1.75 inches) high. Its
net weight shall be 6.8 pounds, and its steel chassis shall be nished in blue. The
unit shall be Aviom, Inc. model AN-16/i v.2.
rev. 1.1 090413
Loading...