Avigilon 1.3C-H4SL-BO1-IR, 2.0C-H4SL-BO1-IR, 3.0C-H4SL-BO1-IR Installation Manual
Installation Guide
Avigilon H4 SL Bullet Camera Models:
1.3C-H4SL-BO1-IR, 2.0C-H4SL-BO1-IR and 3.0C-H4SL-BO1-IR
Important Safety Information
This manual provides installation and operation information and precautions for the use of this camera. Incorrect
installation could cause an unexpected fault. Before installing this equipment read this manual carefully. Please
provide this manual to the owner of the equipment for future use.
The Warning symbol indicates the presence of dangerous voltage within and outside the product
enclosure that may constitute a risk of electric shock, serious injury or death to persons if proper
precautions are not followed.
The Caution symbol alerts the user to the presence of hazards that may cause minor or moderate injury
to persons, damage to property or damage to the product itself if proper precautions are not followed.
WARNING — Failure to observe the following instructions may result in severe injury or death.
l Installation must be performed by qualified personnel only, and must conform to all local codes.
l This product is intended to be supplied by Power over Ethernet (PoE) that is a “Limited Power Source” or
“LPS”, rated 48 VDC, 9W min.
l Any external power supply connected to this product may only be connected to another Avigilon
product of the same model series. External power connections must be properly insulated.
l Do not connect directly to mains power for any reason.
CAUTION — Failure to observe the following instructions may result in injury or damage to the camera.
l Do not install near any heat sources such as radiators, heat registers, stoves, or other sources of heat.
l Do not subject the cables to excessive stress, heavy loads or pinching.
l Do not open or disassemble the device. There are no user serviceable parts.
l Refer all servicing to qualified personnel. Servicing may be required when the device has been damaged
(such as from a liquid spill or fallen objects), has been exposed to rain or moisture, does not operate
normally, or has been dropped.
l Do not use strong or abrasive detergents when cleaning the device body.
l Use only accessories recommended by Avigilon.
Regulatory Notices
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
ii
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and the receiver.
l Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
l Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved by Avigilon Corporation or parties
authorized by Avigilon Corporation could void the user’s authority to operate this equipment.
Disposal and Recycling Information
When this product has reached the end of its useful life, please dispose of it according to your local
environmental laws and guidelines.
Risk of fire, explosion, and burns. Do not disassemble, crush, heat above 100 °C (212 °F), or incinerate.
European Union:
This symbol means that according to local laws and regulations your product should be disposed of separately
from household waste. When this product reaches its end of life, take it to a collection point designated by local
authorities. Some collection points accept products for free. The separate collection and recycling of your
product at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner
that protects human health and the environment.
Legal Notices
©2016 -2017,Avigilon Corporation. All rights reserved. AVIGILON, the AVIGILON logo, AVIGILONCONTROL
CENTER, ACC, and TRUSTED SECURITY SOLUTIONS are trademarks of Avigilon Corporation. Other names
mentioned herein may be the trademarks of their respective owners. The absence of the symbols ™ and ® in
proximity to each trademark in this document is not a disclaimer of ownership of the related trademark. Avigilon
Corporation protects its innovations with patents issued in the United States of America and other jurisdictions
worldwide: avigilon.com/patents. Unless stated explicitly and in writing, no license is granted with respect to
any copyright, industrial design, trademark, patent or other intellectual property rights of Avigilon Corporation or
its licensors.
iii
Disclaimer
This document has been compiled and published covering the latest product descriptions and specifications.
The contents of this document and the specifications of the products discussed herein are subject to change
without notice. Avigilon Corporation reserves the right to make any such changes without notice. Neither
Avigilon Corporation nor any of its affiliated companies: (1) guarantees the completeness or accuracy of the
information contained in this document; or (2) is responsible for your use of, or reliance on, the information.
Avigilon Corporation shall not be responsible for any losses or damages (including consequential damages)
caused by reliance on the information presented herein.
Avigilon Corporation
avigilon.com
PDF-H4SLBO-A
Revision: 2 - EN
20170307
iv
Table of Contents
Overview 1
Mounting Bracket View 1
Rear View 2
Front View 3
Configuration Panel View 4
Side View 5
Installation 6
Camera Package Contents 6
Precautions for Installing Near Salt Water 6
Installation Steps 6
Mounting the Bullet Camera 7
Removing the Configuration Panel Cover 10
(Optional) Using the USB Wi-Fi Adapter 10
Assigning an IP Address 11
Accessing the Live VideoStream 11
Aiming the Camera 11
(Optional) Configuring microSD Card Storage 13
Configuring the Camera 13
For More Information 13
LED Indicators 15
Resetting to Factory Default Settings 16
Setting the IP Address Using the ARP/Ping Method 17
Specifications 18
Limited Warranty and Technical Support 20
v
Overview
Mounting Bracket View
1.
Camera mounts
Points for installing the camera to the mounting bracket.
2.
Mounting hook slots
Points to hold the camera to the mounting bracket while connecting the required cables.
3.
Mounting holes
Holes for securing the mounting bracket to the mounting surface.
Overview 1
Rear View
1.
Ethernet port
Accepts power and Ethernet connection to the network.
The camera can only be powered by Power over Ethernet (PoE). Server communication and image data
transmission also occur over this connection.
2.
Serial number tag
Device information, product serial number and part number label.
3.
Camera mounting screws
Screws for mounting the camera to the mounting bracket.
4.
Mounting hooks
Hooks to attach the camera to the mounting bracket while connecting the required cables.
Rear View 2
Front View
1.
IR illuminator
Provides scene illumination in the IR spectrum.
2.
Configuration panel cover
Covers the configuration panel.
Front View 3
Loading...