9419 WIFIMODULE INSTALLATION GUIDE
Use these instructions to install the WiFi module on the Avery Dennison® Monarch® 9419 Printer.
Use the Printer Management Utility to configure the WiFi s ettings. For information, refer to the
Offline/Online System Administrator’s Guide.
You need a small Phillips screwdriver t o install the WiFi module.
Caution: Electrostatic discharge can da mage or destroy the printhead or e lectronic components.
1. Turn the cover latches and lift the cover.
2. Remove the WiFi module cover.
3. Insert the WiFi module in the slot.
Note: The wireless module has a
flat corner to match the
opening in the printer; the
module must be inserted as
shown.
Avery Dennison® and Monarch® are registered trademarks of Avery Dennison Corporation.
TC9419WFIG Rev. AA 9/16 ©2016 Avery Dennison Corp. All Rights Reserved.
4. Press the WiFi module until it snaps into place.
5. Replace the WiFi module cover.
2
Loading...