TC6054OI Rev. AA 5/11 ©2010 Avery Dennison Corp. All rights reserved.
6054 Network
Control Module
6055 Docking Modules
OPERATING INSTRUCTIONS
Use these Operating Instru ctions to assemble and use
the 6054 Network Control Module and the 6055 Docking
Module.
The 6054 Network Control Module controls one to four
6055 Docking Modules, which provides Pathfinder® 6057
printer charging and Ethernet communication capability
The 6054 Network Control Module and the 6055 Docking
Module can only be used with printers that contain the
approved battery as listed in the printer documentation.
Refer to the Operator’s Handbook for additional impo rtant
battery safety information.
Follow the operating a nd storage limit specifications
listed at the end of these instructions. Otherwise, the
battery may permanently lose its charge capacity.
Note: You must charge the printer b efore using it.
2
Assembling the Network Control Module
1. Turn over the 6055 Docking Module and 6054 Network
Control Module.
2. Using a Philips screwdri ver, remove the end cap from
the Network Control Module.
3. Using a Philips screwdriver, loosen two screws on the
6055 Docking Module an d slide the connector plate
under the screws. Tighten the screws.
Connector Plate
Docking
Module
Network Control
Module
Network Control
Module
End
Cap
3
4. Loosen the two screws on the 6054 Network Control
Module and slide the 6054 Network Control Module
onto the Docking Module’s connec tor plate. Tighten
the screws.
5. Using a Philips screwdri ver, attach the end cap to the
end of the 6055 Docking Module.
6. Carefully turn over the Network Control Module.
You can connect up to four Docking Modules wit h each
Network Control Module. Repeat steps 3 – 6 for each
additional Docking Module. Make sure you attach the
end cap to the final Docking Module.
End
Cap
Loading...