Avertx HD438 User Manual
MOUNTING TEMPLATE
HD438 BULLET CAMERA
PRINTING INSTRUCTIONS MOUNTING INSTRUCTIONS
To print this document, you can right-click the screen, and
then click print to print from your browser. You can also
download the document to your computer, open it in Adobe
Reader or another program, and print using that program.
Make sure you select the option to print this document
at its actual size. Failure to do so may result in an
incorrect size for this template.
To conrm that you have printed at actual size, use the
ruler graphic below. Each division on the graphic should be
1 inch in length when measured with a ruler or measuring
tape.
EACH SECTION OF THE RULER GRAPHIC
SHOULD MEASURE 1 INCH WHEN THIS
DOCUMENT IS PRINTED
Once you have printed the mounting template, follow these
instructions to drill holes for your camera.
1. Cut around the outer circle of the camera template.
2. Tape the template to the location you want to mount
your camera.
3. Use a 7/8 inch drill bit to drill through the paper and
wall or ceiling for the cable connection.
4. If you are using the plastic anchors to mount the
camera, use a 1/4” bit to drill a hole through the paper
and wall or ceiling for the plastic anchors.
5. If you are mounting directly to wood or into a stud,
use a 1/16” bit to drill a pilot hole for the included
screws through the paper and wall or ceiling.
6. Remove the template from the location.
7. Insert the plastic anchors into the smaller holes.
8. Follow the installation instructions included with your
camera.
2 3/4” (68mm)
diameter
2 5/32” (55mm)
diameter OC
1/16” hole
Cable
Cutout
7/8” hole
1/16” holes
37139AA
Loading...