4
Important safeguards
READ ALL INSTRUCTIONS BEFORE USING YOUR ISIS iQ UNO™ BREAST PUMP
When using electrical products, especially when children are present, basic safety
precautions should always be followed, including the following.
WARNING – To reduce the risk of fire, electrocution
or other personal injury:
• Always unplug from the electrical wall socket immediately after use.
• Do not use while bathing.
• Do not place or store the product where it can fall or be pulled into a bath or sink.
• Do not place or drop the control handle, battery pack or wall plug lead into water or other liquids.
• Do not reach for a product that has fallen into water. Unplug from the wall socket immediately.
• Close supervision is necessary when this product is used near children or persons with disabilities.
• Do not allow children or pets to play with the control handle, battery pack, wall plug lead or
accessories as these parts may pose a choking or strangulation danger.
• Never operate this product if it has a damaged lead or plug, if it is not working properly,
if it has been dropped or damaged, or has been submerged in water.
• Only use attachments recommended by AVENT.
• Do not use outdoors or where aerosol spray products are being used, or where oxygen is
being administered.
• Equipment not suitable for use in the presence of flammable anaesthetic mixture with
air, or with oxygen or nitrous oxide.
• Only use the wall plug lead and battery pack supplied with the product.
• There are no user serviceable parts inside the ISIS iQ UNO. Do not attempt to open, service
or repair the ISIS iQ UNO yourself.
• Keep leads away from heated surfaces.
• This product is a personal care item and should not be shared between mothers.
• Do not attempt to remove pump body from the breast whilst under vacuum. Press the
control button to revert to manual control then break the seal between the breast and
the pump body with your finger.
• Do not operate unless control handle is connected to a pump body.
• Never use when sleepy or drowsy.
CAUTION – To reduce the risks of injury, device malfunction
or failure:
• The product should not be left unattended when plugged into an electrical wall socket.
• Never drop or insert any foreign object into any opening.
• Make sure the voltage of the wall plug lead is compatible with the power source.
• Plug the end of the wall plug lead into the control handle first, then securely attach the
wall plug into the electrical socket.
• Although compliant with applicable EMC directives, this equipment may still be susceptible
to excessive emissions and/or may interfere with more sensitive material.
• Wash, rinse and sterilise the appropriate pump parts before each use.
• Do not continue pumping for more than five minutes at a time if no result is achieved.