Page 1
SAFETY DATA SHEET
Section 1 - Chemical Product and Company Information
Product Name: Aveho
Product Type: Odor Removal Technology
Emergency 24-hour Phone (English): CHEMTREC Number +(800) 424-9300
Company Information: UltraTech International, Inc.
11542 Davis Creek Court
Jacksonville, Florida 32256 USA
Date Updated: 10/12/2015
e-mail:
Web:
Telephone:
Fax:
[email protected]
avehotechnology.com
8774228027 904-854-4428 (M-F 8:00 a.m. - 5:00 p.m. EST)
904-292-1325
Section 2 - Hazards Identification
Physical
Health
Not hazardous Not hazardous
This product is not hazardous in accordance with US OSHA 29CFR1910.1200 (Hazcom 2012), Canada Hazardous
Products Regulations (WHMIS 2015), Regulation (EC) No. 1272/2008 (CLP) and the Globally Harmonized System
(GHS).
Environmental
Not hazardous
Section 3 - Composition/Information on Ingredients
Chemical Name
CAS number /
EINECS Number /
REACH Reg. Number
% (w/w)
CLP/GHS Classification
(1272/2008)
Copper Chloride 10125-13-0 / 231-210-2 <0.1% Acute Toxicity Category 4 (H302, H312)
Skin Irritation 2 (H315)
Eye Damage Category 1 (H318)
Aquatic Acute Toxicity Category 1
(H400)
Aquatic Acute Toxicity Category 2 (H411)
Amorphous silica,
colloidal nanoparticles
Non-Hazardous Ingredients
and ingredients below cuto concentrations
7631-86-9 / 231-545-4 <1% Not classified as hazardous
Mixture Balance Not classified as hazardous
1 of 6
Page 2
Date Updated: 10/12/2015
SAFETY DATA SHEET
Section 4 - First Aid Measures
Inhalation: No first aid should be needed. If irritation occurs or symptoms develop, get medical
attention
Skin Contact: Wash skin with soap and water. If irritation develops and persists, get medical attention.
Eye Contact: Immediately flush eyes with water while lifting the upper and lower lids. Get medical
attention if irritation persists.
Ingestion: Rinse mouth with water. Do not induce vomiting unless directed to do so by medical
personnel. Never give anything by mouth to a person who is unconscious or convulsing.
Get medical attention if symptoms develop
Symptoms: May cause mild eye and skin irritation. Ingestion may cause gastrointestinal distress.
Inhalation of mists may cause upper respiratory tract irritation.
Section 5 - Fire Fighting Measures
Extinguishing media: Use any extinguishing media suitable for the surrounding fire.
Unusual fire or explosion hazards: Product is not flammable or combustible. Thermal decomposition prod-
ucts that may develop after the water has evaporated may include cop per oxides and chlorine compounds.
Special firefighting procedures: Firefighters should wear positive pressure self-contained breathing appa ratus and full protective clothing for all fires involving chemicals. Cool
fire exposed containers with water.
Section 6 - Accidental Release Measures
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary
and unprotected personnel.
Environmental precautions: Prevent spill from entering sewers and water courses. Report releases as required
by local and national authorities.
Clean-up methods: Contain and collect with an inert absorbent material. Place in an appropriate
container for disposal. If product has dried, collect dry residue in a manner that
minimizes the generation of dust.
Section 7 - Handling & Storage
Handling: Avoid breathing spray mists. Avoid contact with eyes, skin and clothing. Wash thoroughly
with soap and water after handling.
Storage: NO special storage required.
Specific Uses: Industrial uses - Odor Elimination. Professional uses - Odor Elimination
2 of 6
Page 3
Date Updated: 10/12/2015
SAFETY DATA SHEET
Section 8 - Exposure Controls/Personal Protection
Employers should complete an assessment of all workplaces to determine the need for, and selection of,
proper exposure controls and protective equipment for each task performed.
Hazardous Component(s) US OEL EU IOEL German Limits UK Limits
Copper Chloride (as Cu) 1 mg/m3 TWA
OSHA PEL/
ACGIH TLV
None
Established
0.01 mg/m3
(respirable) TWA
0.02 mg/m3
(respirable) STEL
1 mg/m3 TWA
2 mg/m3 STEL
Amorphous silica,
colloidal nanoparticles*
80 mg/%SiO2
TWA OSHA PEL
None
Established
4 mg/m3
(inhalable) TWA
6 mg/m3
(inhalable), 2.4
mg/m3
(respirable) TWA
* The exposure limits listed may not adequately protect workers from eects of exposure to nano-scale materials.
EXPOSURE CONTROLS:
Appropriate Engineering Controls:
Use with adequate general or local exhaust ventilation to minimize exposures levels.
Personal Protective Measures
Respiratory controls:
None needed under normal use conditions. If exposure levels are excessive and
irritation is experienced, an approved particulate respirator is recommended.
Selection of respiratory protection depends on the contaminant type, form and
concentration. Select in accordance with local regulations and good Industrial
Hygiene practice.
Skin protection: Impervious gloves recommended if needed to avoid prolonged skin contact.
Eye/face protection: Safety glasses or goggles recommended if needed to avoid eye contact.
Section 9 - Physical & Chemical Properties
Appearance (Physical state, Color, Etc.): Blue liquid
Odor: No odor
Odor threshold: Not applicable
pH: 7-8
Vapor pressure: Same as water
Relative density: 1.1 - 1.2
Boiling point/range: 212°F (100°C)
Melting point/ range: 32°F (0°C)
Vapor density: Same as water
Flash point: None
Flammable (solid, gas): Not applicable
Flammable limits: LEL: None
Auto-ignition temperature: None
Evaporation rate: Same as water
Solubility: Soluble in water
Partition coecient (n-octanol/water): Not available
VOC content: 0%
Viscosity: Same as water
Decomposition temperature: Not available
Explosive Properties: Not applicable
UEL: None
Oxidizing Properties: Not Oxidizing
3 of 6
Page 4
Section 10 - Stability & Reactivity
Date Updated: 10/12/2015
SAFETY DATA SHEET
Stability:
Hazardous reactions: None known.
Hazardous decomposition products: Thermal decomposition products that may develop after the water has
evaporated may include copper oxides and chlorine compounds.
Incompatible materials: None known.
Reactivity: Not reactive.
Conditions to avoid: Extreme heat; temperatures below 40° F (5° C)
Stable.
Section 11 - Toxicological Information
Potential Health Eects/Symptoms
Inhalation:
product contains nanoparticles. The eects of inhaling nanoparticles has
not been well studied. Avoid generating and inhaling airborne particulates in the
form of dusts or mists.
Ingestion: May cause mucous membrane and gastrointestinal irritation and other adverse
eects.
Skin contact: Prolonged skin contact may cause mild skin irritation.
Eye contact: Contact may cause mild irritation with redness and tearing.
Chronic Eects: Prolonged overexposure to copper may cause blood, liver and kidney damage.
Prolonged overexposure to dust or mist of colloidal silica (synthetic amorphous
silica) may cause lung damage (pneumoconiosis).
Inhalation of aerosol may cause irritation to the upper respiratory tract. This
Sensitization: Components are not known to be sensitizer.
Skin corrosion/irritation: Inhalation of aerosol may cause irritation to the upper respiratory tract. This
product contains nanoparticles. The eects of inhaling nanoparticles has
not been well studied. Avoid generating and inhaling airborne particulates in the
form of dusts or mists.
Eye damage/ irritation: Copper chloride causes eye damage but the product is not classified based on
the low concentration.
Respiratory Irritation: No data available. Expected to cause only temporary irritation.
Respiratory Sensitization: Components are not respiratory sensitizers.
Skin Sensitization: None of the components have been shown to cause skin sensitization.
Germ Cell Mutagenicity: Components are not germ cell mutagens.
Carcinogenicity: None of the components of this product are listed as carcinogens by IARC, NTP,
US OSHA or the EU CLP or classified as carcinogens under the GHS.
Reproductive Toxicit: No adverse eects are expected. Components are not reproductive toxins.
Specific Target Organ Toxicity:
Single Exposure: No adverse eects are expected.
Repeat Exposure: No data available.
Acute Toxicity Values:
Copper chloride: LD50 oral rat 584 mg/kg, Dermal rat LD50 1224 mg/kg (read-across)
4 of 6
Page 5
Date Updated: 10/12/2015
SAFETY DATA SHEET
Section 12 - Ecological Information
Toxicity: Copper Chloride: 96 hr LC50 Oncorhynchus mykiss 0.068-0.094 mg/L, 48
hr EC50 daphnia magna 0.0338 – 0.792 mg/L, 72 hr ErC50 Phaeodacty
lum tricornutum 0.0057 mg/L Copper chloride is classified in category 1
for acute toxicity with a M factor of 10 and in category 2 of chronic toxicity.
Persistence and degradability: Biodegradation does not apply to inorganic substances.
Results of PBT and vPvB assessment: Components are not classified as PBT or vPvB.
Section 13 - Disposal Considerations
Recommended method of disposal: Dispose in accordance with all local and national regulations. No spe-
cific disposal method is recommended. It is the responsibility of the user,
at the time of disposal, to determine whether the product meets
the criteria for hazardous waste.
Section 14 - Transport Information
14.1
UN
Number
US DOT Not Regulated
Canadian TDG Not Regulated
EU ADR/RID Not Regulated
IMDG Not Regulated
IATA/ICAO Not Regulated
14.2
UN Proper Shipping Name
14.3
Hazard
Class(s)
14.4
Packing
Group
14.5
Environmental
Hazards
Section 15 - Regulatory Information
United States Regulatory Information
TSCA 8 (b) Inventory Status: All components are listed or are exempt from listing on the Toxic
Substances Control Act Inventory.
TSCA 12 (b) Export Notification: None above reporting de minimis
CERCLA/SARA Section 302 EHS: None.
CERCLA/SARA Section 311/312: Not Hazardous.
CERCLA/SARA Section 313: This Product Contains the Following Chemicals Subject to An-
nual Release Reporting Requirements Under the SARA Section
313 (40 CFR 372). Copper Compounds <0.1%
California Proposition 65: This product does not contain chemicals listed per the Safe
Drinking Water and Toxic Enforcement Act of 1986.
5 of 6
Page 6
Date Updated: 10/12/2015
SAFETY DATA SHEET
California Proposition 65: This product does not contain chemicals listed per the Safe
Drinking Water and Toxic Enforcement Act of 1986.
International Regulations
Canadian Environmental Protection Act: All of the components are listed on the Canadian
Domestic Substances List.
European Union: All of the components are listed on the European Inven tory of New and
Existing Chemical Substances (EINECS) inventory.
Australia: All of the ingredients of this product are listed on the Australian Inventory
of Chemical Substances (AICS).
Korea: All of the components of this product are listed on the Korean Existing
Chemical List (KECL).
Japan: All of the components of this product are listed on the Japanese Existing
and New Chemical Substances List (ENCS).
New Zealand: One or more of the components of this product are not listed on the
New Zealand Inventory of Chemicals (NZIoC).
Philippines: All of the components of this product are listed on the Philippine Inven
tory of Chemicals and Chemical Substances (PICCS).
Taiwan: All the components are listed on the existing chemicals inventory.
Section 16 - Other Information
CLP/GHS Classification and H Phrases for Reference (See Section 3)
H302 Harmful if swallowed.
H312 Harmful in contact with skin.
H315 Causes skin irritation.
H318 Causes serious eye damage.
H400 Very toxic to aquatic life.
H411 Toxic to aquatic life with long lasting eects.
SDS Revision History: Changes to Sections 3, 8 and 11.
Date of SDS preparation: October 3, 2015
Date of previous revision: September 1, 2015
Further information
This safety datasheet only contains information relating to safety and does not replace any product information
or product specification.
The information this safety data sheet is believed to be accurate and is the best information available to UltraTech International, Inc. This
document is intended only as a guide to the appropriate precautions to handling a chemical by a person trained in chemical handling.
UltraTech International makes no warranty of mechantability and any other warranty, express or implied with respect to such information
or the product to which it relates, and we assume no liability resulting from the use, misuse or handling of the product to which the safety
data sheet relates. Users and handlers of this product should make their own investigations to determine the suitability of the information
provided herein for their own purposes.
6 of 6
Loading...