AVE RG-2RS User Manual

AVE

The A VE Radar Gun Interface consists of two main components, the VSI-Plus text inserter and the RG-2RS radar gun interface. This radar gun interface will work with the following radar guns: Decatur Hunter, Genesis l & ll, Stalker, & Kustom

The 8 position dipswitch on the RG-2RS is used to select the radar gun and the baud rate if necessary.

Radar Gun

SW1 SW2 SW3 SW4 SW5 & SW6 off off off off Are unused Genesis on off off off (off) Hunter off on off off Stalker off on off off Stalker ATR off off on off Stalker Dual SL on on off off Kustom

Baud Rate

SW7 SW8 off off 1200 on off 2400 off on 4800 on on 9600

RADAR GUN INTERFACE for RG-2RS

INSTALLATION GUIDE

Cable Between the RG-2RS and the VSI: RG-2RS DB-9 VSI DB-9

3-------------------------2 1-------------------------5

Interfacing with Decatur Hunter and Genesis l & ll:

Connect TXD on the radar gun to Pin 3 (RXD) on the DB-25 of the RG-2RS and Ground to Pin 7. Use the 8 position dipswitch to select Hunter or Genesis and the proper baudrate.

Interfacing with Stalker:

Make the following connection:

RG-2RS DB-25

RXD

GND

On the 8 position dipswitch, select Stalker and 9600 for the baudrate.

WHITE

RED (+V)

BLACK (GND)

Interfacing with KUSTOM:

Make the following connection:

RG-2RS DB-25

19-----------------------------------------------------10 13-----------------------------------------------------3

7-------------------------------------------------------8

On the 8 position dipswitch, select KUSTOM and 9600 for the baudrate.

KUSTOM 15 PIN MALE

AmericanVideoEquipment

1617 E. RICHEY ROAD • HOUSTON, TEXAS• 77073 • PHONE: (713)443-2300 • FAX: (713)443-8915

1234567890123456789012345678

AVE

RADAR GUN INTERFACE for RG-2RS

INSTALLATION GUIDE • pg. 2

Interfacing with Stalker ATR:

Make the connection as shown below:

RG2RS DB-25

GND

R X D

4-pin Din connector (female)

On 8-position Dip Switch, select Stalker ATR. Set baudrate to 9600.

Interfacing with Stalker Dual SL:

Make cable connection between RG2RS and Stalker Dual SL, as shown below:

7 3

GND

DATA

On 8-position Dip Switch, select Stalker Dual SL. Set baudrate to 9600.

NOTE: To use this interface, you must configure the radar gun serial port to b format and one of the following baudrates: 1200, 2400, 4800, 9600. For example, configuration bAu 12 b, which means 1200 baud and b format, will work with this interface.

AmericanVideoEquipment

1617 E. RICHEY ROAD • HOUSTON, TEXAS• 77073 • PHONE: (713)443-2300 • FAX: (713)443-8915