Avaya Passport 5430 Important Notice
Important Notice for the Passport 5430 Switch
This notice provides information about PMC module installation on Passport 5430
Multiservice Access Switch cards and UL marking. Please read both sides of this notice.
Caution:
The Passport 5430 will not operate correctly unless you install the
PMC modules on the appropriate cards. Refer to the following table and
figure.
You must install the PMC modules on the Passport 5430 cards as follows:
System
PMC Module
ATM T1/E1
Dual synchr onous ✔
Module 3
Module 4
Module 5
Remote
Console
U
ISDN BRI
Telco
withNT1
V.34 Modem
Processor Card Expansion Card
✔
COM
COM
ATM T1/E1 PMC module
Voice Processor
Expansion Card
Expansion Card
System
Processor
PCI Slot 1
PCI Slot 2
PCI Slot 3
PCI Slot 4
Dual synchronous PMC modules
FBR0103A
For more information, refer to Installing and Operating the Passport 5430 Multiservice Access
Switch.
The UL marking label is affixed to the back of the empty Passport 5430 chassis. However, the
chassis is not actually UL listed until the components are installed.
щсфммончк0'5F0ффщ
The UL-listed Passport 5430 consists of a chassis that contains these Passport 5430 components:
• One or two power supplies (Delta Model DPS-180JB X)
• One system processor card
• Up to three cards for expansio n
• One or two dual synchronous PMC modules installed on each expansion card
• One ATM T1/E1 PMC module installed on the system processor card
• Up to three of the following WAN adapter modules:
— FT1/T1 DSU/CSU
— FE1/E1 DSU/CSU
— 64K DSU/CSU
— BRI S/T
— ISDN BRI U
—Serial
— V.34 modem
• One V.34 console modem module
щсфммончк0'5F0ффщ
Loading...