Avanti RS47BM Installation Manual

MODEL: RS47BM

Your Avanti Room Security Safe is supplied with the following:

1 – Security Safe Unit

4 – 1.5V – AA Size Batteries

4 – Rubber Feet

2 – Emergency Access Keys

1 – Felt Liner

1 – Installation / Usage Guide

Installation Screws

1

9

Door

Rubber Feet

INSTALLING YOUR SECURITY SAFE

SECURITY SAFE

INSTALLATION AND USAGE INSTRUCTIONS

2
3
4
5
6
7
8

Cabinet
Knob
Key Hole
LCD Display
Control Panel
External Power Outlet
Key Hole Cover Access

When installing your safe, be sure the location is sturdy enough to support the unit and is both
secure and easy to access.

Safe can be installed onto either a concrete or wooden surface.

When installing use a 25/64” (10mm) drill bit and screws.

To prevent removal of your security safe, it is recommended to use Allen type screws (not included)
to affix the unit to the installation location.

INITIAL SETUP AND CONFIGURATION.

GUEST / USER CODE SETUP

Manual Operation (Open using the key).

• User will need to remove the key hole cover by placing a small pin or similar object in the
hole below the keyhole and key hole cover.

• Insert the emergency access key into the lock and turn clockwise to open the safe.

• While the door is open, change the batteries on the control panel or reset the passcode as
described in the “Resetting the Password” section.

After you have installed the unit in its final location, proceed to set up digital access controls.

1) Using the Emergency Access Key, open the safe.

2) Open the battery compartment cover.

3) Following the image shown in the battery compartment install the 4 AA sized batteries.

4) Close the battery compartment cover.

5) The words “ALL READY” will be displayed on the LCD display for approximately 1 second; the

security safe will then go into “STANDBY Mode”.

6) Once in “STANDBY Mode” the LCD display will show the date and time (YY, MM, DD).

7) Press the “ # “ button to activate the keypad.

8) Using the keypad, enter the initial setup password “1234”

9) Press the “ # “ button to confirm

Setting the Date, Time and Weekday:

• After the batteries have been installed, the LCD display will show “00-01-01” (Year-Month­Date) and “Week 1” (Monday) “00-00” (Time).

• Press the “*” to enter the programming mode, the “00” will begin to flash.

• Increase by pressing the “ 8 “ or Decrease by pressing the “ 0 “, when finished press the
“#” to move to the next item.
When finished programming, do not touch any key for approximately 7 seconds and the
program will t ake effect.

To reset the access code read and follow the steps below.

1) With the door open, press the “#” to activate the key pad, enter the default code (1234) and

press the “#” key to confirm.

2) You will hear two beeps and the LCD display will show “OPEN”

3) Within 7 seconds press the “ * “ button to change the primary password.

4) After pressing the “ * “ button “ - - “ will be shown in the LCD display.

5) Enter the new 4 – 8 digit code and press the “ # “ to confirm.

6) Once the code has been confirmed the word “ INTO “ will be shown in the LCD screen.