Avanti M07180TW Installation Manual
Installation & Assembly
Qty
Microwave Oven Bracket Installation Instruction
(Only to be used in models MO699SST-1/MO7080MW/MO7090MB/M07180TW/MO7280TB installation)
Parts List &
Hardware
Microwave Oven Models MO699SST-1/MO7080MW/MO7090MB/M07180TW/MO7280TB
Part Number
A MOM9704 1 Mounting Bracket
B 9704-001 2 Locking Pin
C 9704-002 3 No. 8 x 5/8” Phillips Hex Head
D 9704-003 4 No. 8 x 1” Phillips Pan Head
E 9704-004 4 Plastic Anchor (¼” x 1”)
Installation Procedures:
1) Bracket Configuration:
Holes (A ), (B) and (C) are the existing holes in the upper part of the Metal bracket. Holes (D), (E), (F) and (G)
are also existing holes in the lower part of the Metal bracket.
See illustration #1.
Before you start this installation make sure you have all the parts listed below.
Read entire installation sheet before you start assembly of this item.
Description
Self Tapping Screw
Sheet Metal Screw
A B C
D
2) Installation of the upper side of the Metal bracket to the Microwave:
Place top of the bracket on the back of the microwave. Insert one of the (3) Phillips Hex Head Self Tapping
screws provided into pilot hole (A) then proceed installing the remaining (2) two Phillips Hex Head Self
Tapping screws into holes (B) and (C).Secure using a Phillips head screwdriver.
See illustration # 2.
1
E F G
Illustration #1
Illustration # 2
3) Installation of the lower side of the Metal bracket to the Refrigerator:
Lay and center the Microwave oven (with bracket installed) on top of the refrigerator.
Flip down the lower part of the bracket.
Using the four (4) existing holes on the bracket as a guide, mark the locations where to drill the holes (D),
(E), (F) and (G ). See illustration # 3.
Illustration # 3
4) Drilling the four holes to the Refrigerator:
After marking the locations of the four (4 ) holes, remove the Microwave oven and bracket from the top of
the refrigerator and proceed drilling the four (4) holes with a ¼” drill bit into the rear of the Refrigerator.
See illustration # 4.
2
Loading...