Avalon Firestyles Winthrop Bungalow User Manual

Page 1
Winthrop (864) Bungalow, Tree of Life
Compatibility:
• 864TRV, 864HH, 864ST Fireplace
Packing List:
• Left and Right Side Door with (2) Magnets Each
• (2) Door Handles
• (2) Hinge Brackets (for mounting the Doors)
Installation Details
99300487 Bungalow 95800386 Tree of Life
• Upper and Lower Grills (Mesh Screen)
• Glass Frame Cover
• (4) or (2) 8-32 x 1/2" Screws (for handles)
• (2) #10 Washers (Tree of Life only)
• (4) Hinge Pins
• (8) 8-32 Nuts
• (6) #8 x 3/8" Screws (for Hinge Brackets)
36-7/8
Bungalow
34
SIDE OF FIREPLACE
Tree of Life
1
3/4
Page 1 of 7 10/16/07 © Travis Industries, Inc.
Page 2
Winthrop (864) Bungalow, Tree of Life
99300487 Bungalow 95800386 Tree of Life
Optional Door Screen Inserts – Bungalow Only
OPTION A - Basket Weave (installed in the doors).
Place the doors in an upright position. Attach the handle (2) to the door with the included screws (3).
Slide the hinge pins (4) into place.
OPTION B – Mesh Door Screen (shipped separately with this kit).
Place the doors (1) face down on a suitable work surface).
Remove the nuts (7) holding the upper (5) and lower (6) inserts in place. Remove the inserts and
install the mesh screens. Note: the screens have a sheet-metal frame spot-welded to them - make sure the sheet-metal faces outward – this protects the screen and covers the sharp edges. Secure the screens with the nuts removed earlier. Do not over-tighten
Place the doors in an upright position. Attach the handle (2) to the door with the included screws (3).
Slide the hinge pins (4) into place.
5
1
4
3
6
7
2
Page 2 of 7 10/16/07 © Travis Industries, Inc.
Page 3
Winthrop (864) Bungalow, Tree of Life
99300487 Bungalow 95800386 Tree of Life
Installation
1 Remove the glass frame from the fireplace (see the owner's manual for details). 2 Install the hinge brackets onto the fireplace following the directions below.
Remove and discard the nuts and bushings attached to the stud plates near the firebox ( falling out, we recommend removing one nut and bushing and installing a nut before removing the second nut and bushing.).
Attach the nuts included with this kit. Do not secure the nuts all the way - leave a 1/8 gap between the nut and the stud plate.
HINT: To prevent the stud plates from
Discard the nuts and bushings.
1/8
Slide the hinge brackets into place
- the slots on the bracket slide over the press studs on the fireplace.
Hand tighten the upper nut. Use a wrench to securely tighten the lower nut to prevent the hinge bracket from bending while the doors are in place.
11/32" Open End Wrench
Secure the hinge brackets to the fireplace with the included screws.
Repeat these steps for the opposite side.
NOTE: The hinge brackets have a notch on the bottom - this helps determine the left bracket from the right bracket.
Hand-tighten these nuts on the stud plates.
Page 3 of 7 10/16/07 © Travis Industries, Inc.
Page 4
Winthrop (864) Bungalow, Tree of Life
99300487 Bungalow 95800386 Tree of Life
3 Install the glass frame cover following the directions below.
Place the cover over the top of the door frame.
4 Attach the glass frame to the fireplace.
Push these pins inwards to lock the cover in place.
Page 4 of 7 10/16/07 © Travis Industries, Inc.
Page 5
Winthrop (864) Bungalow, Tree of Life
99300487 Bungalow 95800386 Tree of Life
5 Install the upper and lower grills (mesh screens) following the directions below.
NOTE: The upper and lower grills are different. The lower grill has end-stops on either side.
Upper Grill Installation
Hold the grill at an angle and insert the lower slot over the bushing on the hinge bracket (both sides). You may need press on the grill to get the tab over the bushing (this prevents the grill from accidentally falling off).
Swing the grill upwards to engage the upper slot. You will need to lift the grill slightly to get it over the bushing. Once in place the grill is held in place by gravity.
Lower Grill Installation
Hold the grill at an angle and insert the lower slot over the bushing on the hinge bracket (both sides). You may need to press on the grill to get the tab over the bushing (this prevents the grill from accidentally falling off).
Bend the end-stop tab over on both sides. This allows the grill to swing forward without disengaging.
Page 5 of 7 10/16/07 © Travis Industries, Inc.
Swing the grill upwards to engage the upper slot. You will need to lift the grill slightly to get it over the bushing. Once in place the grill is held in place by gravity.
Page 6
Winthrop (864) Bungalow, Tree of Life
99300487 Bungalow 95800386 Tree of Life
6 Insert the hinge pins into the hinges on the door. Hold the doors at a 90° angle to the fireplace and hang the
doors on the hinge brackets (see the illustration below). Swing the doors closed - NOTE: the left door closes behind the right door.
Hold each door at a 90°angle to the backing plate and hang in place.
ADJUSTING THE HINGES:
The hinges may be adjusted by bending the tabs to the left or right. This allows the doors to be aligned left or right, top to bottom. NOTE: place a rag over the hinge posts before grasping the hinge posts with pliers to prevent scratching.
NOTE FOR INSTALLATIONS WITH THICK FACINGS (e.g.: BRICK, ROCK): The hinge pins can be slid into
place after the doors are aligned over the hinge brackets. This eliminates the need to "drop" the doors into place.
Page 6 of 7 10/16/07 © Travis Industries, Inc.
Page 7
Winthrop (864) Bungalow, Tree of Life
99300487 Bungalow 95800386 Tree of Life
7 Magnets are shipped attached to the doors. Position the magnets on the back side of both doors as shown
below. The magnets have felt attached to one side – make sure the felt side contacts the fireplace (this keeps the magnets adhered to the door, not the fireplace). Attach the handles as shown below.
NOTE: The magnets are shipped attached to the doors. These powerful magnets may require pliers to
properly position. Take care with the magnets to prevent damage and keep them away from children.
Attach the door handles as shown to the left. The tree
of life handles require a washer and screw, the
bungalow requires two screws.
Confirm that the magnets are in these locations (with the felt facing up). These
magnets attach to the doors and help keep the doors shut when in use.
Page 7 of 7 10/16/07 © Travis Industries, Inc.
Loading...