Winthrop ST (864 ST) Enamel Fireback
Installation Instructions (sku 96100185)
Packing List
• (4) Floor Firebacks
• (2) Side Firebacks
Installation
WARNING:
Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
1 Remove the glass frame and logs.
2 Remove the front and rear grates (NOTE: lift the burner slightly to remove the grate - see illustration below).
NOTE: If the accent light deflectors have been bent, carefully bend the accent light deflectors inwards on
both sides (NOTE: do not over-bend these deflectors, they will break off if over-bent).
3 Remove and discard the steel ember trays.
Page 1 of 2 17601579 - 7/13/11 © Travis Industries, Inc.
Winthrop ST (864 ST) Enamel Fireback
4 Carefully place the floor
firebacks into position.
You must tip them under
and around the corners of
the burner. Once in
place, bend the accent
light deflectors back to
the correct position (take
care to not damage the
halogen bulbs).
5 Carefully replace the front
and rear grates (they rest
on top of the floor
firebacks).
Installation Instructions (sku 96100185)
6 Install the side firebacks
following the directions
below.
7 Restore the fireplace to
the correct configuration.
Cleaning
We recommend cleaning the enamel surface with glass cleaner and a soft cloth.
Page 2 of 2 17601579 - 7/13/11 © Travis Industries, Inc.
Loading...