Avalon Firestyles Pellet Remote Thermostat User Manual

Compatibility

Wall Thermostat

SKU 99300650

• All Travis Gas Stoves

• 33 DVI Insert

• 31 DVI Insert

• 564 SS and DF

• 864 TRV, ST, and HO

• All Travis Pellet Stoves or Inserts

Packing List

• Thermostat

• Thermostat Wire (20’)

• (2) Screws (for attaching thermostat)

Installation Warnings

! Shut off power to the appliance and allow it to cool prior to installation.
! This kit must be installed by a qualified technician.
! Do not connect 110 VAC to the gas control valve or on/off switch on gas heaters or the thermostat

posts on pellet heaters.

Follow the instructions on the following pages for the type of model being addressed.

Wire Connection - Pellet Heaters

Attach the thermostat wire to the circuit board.

Open the hopper lid and remove the

a

screw holding the right panel in place.

Swing the
panel
open.

d

Phillips
Screwdriver

b

If necessary, attach the
pellet stove connector
wires to the ends of the

c

Route the wires up to the circuit
board and attach the quick-connects
to the thermostat posts (orientation
does not matter).

Bundle up any excess wire with a
lock-tie to prevent it from contacting
any hot or moving parts

receiver wires.

Page 1 of 3 2/2/11 - 17601040 © Travis Industries, Inc.

Wall Thermostat

SKU 99300650

Wire Connection - Gas Heaters

Do not connect 110-120 VAC to the gas control valve or wiring system of this fireplace. The thermostat

and wiring must be installed by a qualified installer.

The included wire allows the installer to connect the thermostat to the on/off switch on the heater. Follow
the directions below to install the splitter in series or parallel connection.

WARNING

NOTE

: Make sure all wiring is secure and does not contact hot or moving components.

: The newer switch has two terminals and is pictured below. Older switches

have four terminals. Use the top and bottom terminal on either side of the
switch when connecting the wires (see the illustration to the right).

Parallel Connection

Thermostat/External Switch ON Heater is ON Heater is ON

Thermostat/External Switch OFF Heater is ON Heater is OFF

To wire the heater in parallel, follow the directions below:

On/Off Switch ON

On/Off Switch OFF

Series Connection

Thermostat/External Switch ON Heater is ON Heater is OFF

Thermostat/External Switch OFF Heater is OFF Heater is OFF

To wire the heater in series, follow the directions below:

On/Off Switch ON

Page 2 of 3 2/2/11 - 17601040 © Travis Industries, Inc.

On/Off Switch OFF