Page 1
Panel Set, Answer, 1250 Insert (see part #’s below)
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on
the carrier's freight receipt. Any damage claims as a result of shipping must be handled through the shipper.
Travis Industries will provide assistance in resolving shipping claims or replacing items not included in the
package. Please report any missing items immediately.
COMPATIBILITY
• Lopi Answer • 1250 Insert
ITEMS NEEDED FOR ASSEMBLY
• 5/16” Nutdriver • Small & Large Standard Screwdriver
PACKING LIST
• Top and Side Panels • Four 10-24 Self-Threading Screws • Trim (with hardware)
• Two Leveling Bolts – for leveling the stove in the fireplace • (7) Spring Clips
PANEL SIZING and PART NUMBERS
Surround Panel Size Size (Including Trim) Black Trim #
8 " 40 1/8" width by 28 1/4" height 99300285
10" 44 1/8" width by 30 1/4" height 99300286
INSTALLATION INSTRUCTIONS
1. With the insert 12” from the fireplace, install the side surround panels (see the directions below).
Attach the side surround panels
(hardware is included with the heater).
ANSWER: Use the included screws
(pre-thread the holes on the insert).
ANSWER ONLY:
Remove and discard the button
plugs from both sides of the insert.
1250 INSERT: Use the included nuts
and bolts.
© Travis Ind. 17601278 Page 1 of 1 Printed 9/1/09
Page 2
Panel Set, Answer, 1250 Insert (see part #’s below)
2. Adjust the position of the side panels so they are: 1) aligned with the top of the insert; 2) both the
same distance back from the front of the insert; 3) perpendicular to the floor (use the top panel, if
necessary, to judge alignment). Tighten the screws that hold the side panels in place.
3. Place the insert into the fireplace and connect the flue (if using a positive or direct connection).
Install the top panel and trim following the directions below.
Micro (1/16”)
Standard
Screwdriver
Spring
Clips
Top Trim
Top
Panel
Install the top panel so the tabs insert
into the joggle clips on the top panel
"L" Bracket
Right Side
Trim
Optional Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Optional Knock-Out
An optional knock-out is provided on both
sides if the power cord is routed behind the
surround panel.
Insulation Installation (required only for face seal installations)
1. With the insert drawn 6" from the fireplace, glue the insulation strip included with the surround
panel kit to the back of the panels using RTV silicon or stove gasket cement. The insulation
should be installed so it overlaps the fireplace opening to form a seal between the panels and the
fireplace face. Let the silicon or cement dry.
2. Push the insert into the fireplace, allowing the insulation to form a seal between the panels and
the fireplace. Use a screwdriver to tuck any exposed insulation behind the panels.
© Travis Ind. 17601278 Page 2 of 2 Printed 9/1/09
Loading...