Avalon Firestyles DVS GSR Firebacks User Manual

DVS GSR / 31 DVI Firebacks

96100100 Brick/Herringbone (2 Sided) - 96100272 Handmade Brick -- 96100273 Reclaimed Brick

Packing List

• Rear Fireback

• (2) Side Firebacks

2-Sided Firebacks

On 2-sided firebacks make sure to use the desired pattern and correct orientation.

NOTE: The rear fireback must be
installed as shown below for the
brick pattern to line up with the
side firebacks.

UP

UP

Installation

WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.

1 Remove the glass frame and logs (see the manual for details).

2 Follow the steps below to install the firebacks (see illustrations on the following page).

a) Remove the burner (see the manual for details).

b) For the DVS GSR bend the accent light down (if installed).

c) Install the rear fireback (see illustration on the following page).

d) Install the side firebacks (see illustration on the following page).

e) For the DVS GSR, return the accent light to the correct configuration.

f) Replace the burner.

3 Restore the appliance to the correct configuration.

Page 1 of 2 17601430 - 9/22/10 © Travis Industries, Inc.

DVS GSR / 31 DVI Firebacks

96100100 Brick/Herringbone (2 Sided) - 96100272 Handmade Brick -- 96100273 Reclaimed Brick

Slide the top of the rear
fireback behind the baffle on
top of the firebox and pivot it
back into place. It rests on
the shelf at the back of the
firebox.

The fireback clip has a
keyhole slot. It can be

removed by loosening

the screw and sliding

the clip out.

Replace the clip

to secure the

side fireback

(both sides).

Remove this clip attached to

the firebox ceiling (both sides).

Hold the side

firebacks at a

slight angle and

place them into

position (both

sides).

Page 2 of 2 17601430 - 9/22/10 © Travis Industries, Inc.