Avalon Firestyles Cambridge Face User Manual
Cambridge Face
Black Paint # 99300452 Black Enamel # 99300453
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on the carrier's freight
receipt. Any damage claims as a result of shipping must be handled through the shipper. Travis Industries will provide assistance
in resolving shipping claims or replacing items not included in the package. Please report any missing items immediately.
COMPATIBILITY
¥ Travis Ind. DVS Insert ¥ Travis Ind. DVS Fireplace
PACKING LIST
¥ Face
¥ Four 10-24 Screws
¥ Two Face Mounting Brackets
INSTALLATION INSTRUCTIONS
! Turn the gas control valve to "OFF" prior
to conducting any service.
1 The log set, coals, and glass must be
installed prior to installing the face (on the
DVS Insert, the panels must be installed as
well).
HINT: It is easiest to install the face
mounting brackets with the glass removed.
2 Install the face mounting brackets
following the directions to the right
3 Install the face following the directions
below.
TOOLS REQUIRED
¥ 3/8" Nutdriver
3/8" Nutdriver
Attach the
face mounting
bracket with
the four
screws
included with
the face.
NOTE:
There is a left and a right face mounting
bracket - make sure the hooks on the
bracket are offset to the outside.
a
Grasp the face by the pillars.
NOTE:
The glass can not be removed without
removing the face. However, with the slideoff face, this process is quick and easy.
b
Line up the edge of the glass with
the opening on the face. Move the
face forward until the tabs on the
face are over the hooks on the face
mounting brackets.
c
Slide the face down, securing the
face at four corners.
Page 1 of 2
10850 117th Place N.E. Kirkland, WA 98033
Printed March 18, 1998
Cambridge Face
FACING CONSIDERATIONS
Cambridge Face Dimensions
2-1/2Ó
Black Paint # 99300452 Black Enamel # 99300453
34-3/8Ó
CLEARANCES:
Face to Sidewall 6Ó
Face to Mantel 17Ó
Face to Side Facing 6Ó
Face to Top Facing 10Ó
Hearth Extension (front) 12Ó
Hearth Extension (sides) 0Ó
Combustibles to Front 36Ó
DVS Fireplaces
NOTE: The facing
above the face must
be flush for 1/2Ó to
allow the face to be
Side View
Two 1/2"
Cement Boards
Wood Sub
Floor
slid in place.
Cambridge Face
33Ó
3/8" Thick
Tile
21-3/4Ó
NOTE: follow all directions
and requirements listed in
the ownerÕs manual.
2Ó
{
DVS Fireplace
1/2" Cement Board & 3/8" thick tile
(tucked behind the face)
1-1/2"
Base of Fireplace
Page 2 of 2
10850 117th Place N.E. Kirkland, WA 98033
Printed March 18, 1998
Loading...