Cambridge DVL Fan Light, Gold Part # 99300458
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on the carrier's freight
receipt. Any damage claims as a result of shipping must be handled through the shipper. Travis Industries will provide assistance
in resolving shipping claims or replacing items not included in the package. Please report any missing items immediately.
COMPATIBILITY
¥ Travis Ind. DVL Insert or DVL Fireplace using the Cambridge Face
PACKING LIST
¥ Fan Light ¥ Fan Light Brackets ¥ Two 10-24 Screws
INSTALLATION INSTRUCTIONS
! Turn the gas control valve to "OFF" prior to conducting any service.
1 Remove the face and glass (see the ownerÕs manual).
2 Install the fan light following the directions below.
NOTE:
The face and glass must be
removed prior to installing
the fan light.
a
Use the included screws
to install the fan light
mounting brackets to the
insert (they attach to the
inside). You may wish to
pre-thread the holes on
the insert prior to
installation.
Fan Light
Mounting
Brackets
5/16Ó Nutdriver
Replace the glass.
b
Face
Mounting
Brackets
IMPORTANT NOTE REGARDING GOLD SURFACES
Prior to starting the heater, clean the gold surface with a soft cloth and denatured alcohol. Any
marks left on the gold surface will permanently etch the gold if heated.
Page 1 of 1
10850 117th Place N.E. Kirkland, WA 98033
Attach the fan light to the heater by
c
sliding the four notches on the fan
light over the hooks on the fanlight
mounting brackets.
Printed March 11, 1999