Avalon Firestyles AGP Stove Side Panels User Manual

AGP Stove Side Panels





(94400024,94400025,94400026)

Compatibility

AGP Stove – SKU 99800511

Packing List

(2) Side Panels (left and right side)

Installation Instructions

Unplug the heater and make sure it is fully cool prior to conducting service.

Hints for Working with Stainless Steel Panels

The optional stainless steel panels are susceptible to finger prints and other marks. We suggest you peel the
protective coating up from the corners and edges of the panels before installing. After the panels are installed,
remove the protective coating. This allows you to handle the panel without leaving marks. Any marks on the panel
may be cleaned using a dry soft cloth (you may also use a stainless steel cleaner). Always wipe the surface in the
same direction as the brushed finish.

1 Remove the thumb screws from both sides of the stove.

2 Remove the handle from the air restrictor on the right side (make sure the black and

white spacers remain in place).

Page 1 of 2 17601850 — 4/30/14 © Travis Industries, Inc.

AGP Stove Side Panels





3 Position one of the side panels so the tabs on the panel line up with the slots on the

front of the stove (see photos below). Hold the panel at a slight angle and insert the
tabs into the slots. Swing the panel into place and secure using the thumb screw
removed earlier. Repeat this process for the remaining panel.

(94400024,94400025,94400026)

4 Replace the handle on the air restrictor.

Hand-Rubbed Patina Finishes

The optional patina finish is hand applied by a skilled artisan to permanently alter the colors and texture of the
metal. Each piece is individually hand-polished and fired in an oven which imparts unique color subtleties with no
two finishes alike. The patina finish is a “living” color and will age and antique over time.

Page 2 of 2 17601850 — 4/30/14 © Travis Industries, Inc.