Autotech VR6, Mk3 User Manual

A U T O T E C H

Installation Instructions

www.autotech.com

Part Number: 10.998.230K; 10.998.232K
Description: SHOCK THERAPY® IGNITION WIRES, VR6

Notes:

Since they will obviously not fit within the grooves made for the stock wires, Autotech's
Shock Therapy® wires for VR6 engines use seven "T-clips" to hold the massive 10.4mm
diameter wires in position on the wire guide/engine cover. A self-tapping screw is used to
mount each clip to the cover. No drilling is required.

T-Clip Installation -

Included with your wire set is 7 nylon clips: 6 dual and 1 single. Each is held to the stock

plastic wire guide with a self-tapping screw. The short screws are used in the front engine
bank's clips, the long screws in the rear bank's.
However, always use a long screw to make the hole for the clip. Once the hole is made, you
can select the proper length screw, depending on where the clip is located.

Remove your stock wires ONE-AT-A-TIME, replacing each with a new Shock Therapy® wire
before removing the next wire. This ensures that you maintain proper firing order (correct
coil terminal to plug connection).

Procedure:

1) Using the plug wire tool, remove the connector from one of the three front spark plugs.

2) Remove the wire from the wire guide by pulling gently upwards, and disconnect the wire
from the coil.

3) Now match the length of the old wire to a new
Shock Therapy® wire, and install the new wire.
At this point, wait until the other two wires are in
place before trying to mount any clips. Repeat this
process until all three wires for the front engine­bank are installed.

Plug wire tool engaged on connector end.

Phone [phone] Fax [phone]-E Paseo Adelanto, San Juan Capistrano, CA 92675

4) Using one of the longer screws to make each hole,
and a shorter screw to mount, attach 3 dual and
1 single clip to the front wire guide as shown at
right. The holes can be made in the raised section
in the guide between the stock wire grooves. Note
the clip positions in the illustrations.

5) Using the remaining 3 dual clips and 3 long screws,
complete the installation for the Shock Therapy®
wires for the rear engine bank by essentially re­peating the process used in step 3.

Close-up of typical hole position in wire guide.

Close-up view of front bank clip positions.

Completed front bank installation

Completed installation.

Phone [phone] Fax [phone]-E Paseo Adelanto, San Juan Capistrano, CA 92675