Page 1
�
4
1
PR-12 Infrared Printer
Instruction Manual
This infrared printer allows test results to be printed at a distance up to
15 feet.
Test Equipment
Auto Meter Products Inc.
413 West Elm Street
Sycamore, IL 60178
Toll Free (866) 883-TEST (8378)
Fax (815)-895-6786
www.autometer.com
Phone (815) 895-8141
2650-1511-00 5/27/10
Page 2
2
3
1. Plug in the AC adapter
or 12 VDC cigarette adapter
and turn the power
switch on. The Red &
Green LED will light up.
2. Point the I/R receiver
that is on the front of
the printer, in the
direction of the vehicle
or tester being used.
3.
4. When the test is complete,
point the tester in the general
direction of the PR-12 Infrared
Printer. Press the print key on
the tester panel. The test
number and results indicated
on the tester LCD will print
out on the PR-12 printer.
5. To feed the paper manually,
Press the LF(Line Feed)
button to start feeding the
paper.(Green LED will go
off during line feed.)Press the
LF button again to stop
feeding. (Green LED will come
back on.) Printer will automatically
stop the feed in 10 seconds, if the
LF button not pressed. You are
now ready to print.
OPERATION
PAPER INSTALLATION
CONGRATULATIONS!
Perform the test using your
Auto Meter hand-held tester.
NOTE:
If the infrared receiver on the printer is
exposed to direct sunlight, the printer
may not function properly. Turn the printer
so that the infrared receiver is not exposed
to direct sunlight, and reduce the printing
distance from hand held testers.
Standard Thermal Paper Roll - (58 mm) Available from any ofce supply
AC Adapter - (120 VAC Output 12 VDC)
DC Adapter - (Cigarette Lighter Adapter. Output 12 VDC)
Printer Dimensions - 4.5” W 5.75” D 3.25” H
You have chosen the PR-12 printer designed for use with Auto Meter
handheld testers. If you should have any questions about this product please
refer to the contact information on the back cover of this manual.
1. Open cover by placing
hands on both sides of
the cover and ipping up
on the nger tabs.
2. Drop in thermal paper roll
(as shown). Pull paper out
3” past the cover lid and
hold.
3. Close lid by pushing on
both sides of the printer
cover at the lid tabs until
you hear a snap. Paper is
loaded and ready to use.
NOTE: SEL button has no function.
Loading...