Auto Meter 4744 User Manual
you may install the probe prior to the turbo. You may consult an engine builder or tuner for recommendations for which probe location is best for you. If installing
A)
⁄
Simply screw the threaded fitting into the hole, insert the probe and tighten the nut already on the probe from the factory.
B)
⁄
manifold or exhaust header. Screw the threaded fitting into the hole, insert the probe and tighten the nut already on the probe. Make sure the probe is oriented so
the wires do not come into contact with, or become too close to, the manifold or other hot engine parts.
⁄
⁄
⁄
the probe. Before tightening the collar in position make sure that when inserted, the probe will have it’s tip in the middle two-thirds of the exhaust stream.
(washer is fragile) push the white ceramic washer over the
⁄
Hold the clamp open when inserting the probe into the
⁄
D)
⁄
⁄
Pass the
⁄
⁄
/
/
⁄
⁄
/
⁄
⁄
/
/
⁄
1. Disconnect the negative (-) battery cable.
⁄
⁄
The 2
⁄
⁄
The hole may be either a hole in the dash, a gauge panel or
an Auto Meter Gauge Pod. (It is best to connect all wiring to
the gauge before mounting it into the gauge hole.)
proper installation.
nuts provided.
+ -
⁄⁄⁄
⁄
*NOTE ON LUNAR SERIES MODELS:
Lunar Series has no external
⁄
YELLOW(+) RED(-)
Auto Meter Products, Inc. warrants to the consumer that all Auto Meter High Performance products will be free from defects in material and workmanship for a period of twelve (12) months from date of the
failed due to defects in material or workmanship. This warranty is limited to the repair or replacement of parts in the Auto Meter instruments. In no event shall this warranty exceed the original purchase price of
the Auto Meter instruments nor shall Auto Meter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the failure of this product. Warranty claims to Auto Meter
413 W. Elm St., Sycamore, IL 60178 USA (815) 899-0801
© 2006 Auto Meter Products, Inc.
Loading...