Auto Meter 2176 User Manual

INSTALLATION INSTRUCTIONS

PRESSURE

PORT

1½" PRESSURE GAUGES

Preliminary Steps

1.  Read instructions thoroughly. Please consult a qualified mechanic if you
  have not had training in the proper installation of instruments.

2.  Determine ideal mounting location. Consult your vehicle’s repair manual
  to locate:  A) Fuel Pressure Port
      B) Oil Pressure Port
      C) Any other Pressure port

CAUTION:  Some late model vehicles use electronic sensors in their
  pressure and temperature senders for engine control functions. Before
  removing the original senders, we recommend that you contact your Auto
  Dealer to be sure no critical functions will be disrupted.
  With pressure gauges, it is beneficial to add a T-fitting to install your new
  gauge and to keep the warning light operational. This allows you to 
  monitor the pressure and still have a warning light to indicate emergency 
  conditions.

INSTALLATION

1.  Locate pressure port.

2.  Install T-fitting if needed.

3.  Apply teflon sealing tape or compound to insure a leak-free connection.

4.  Install gauge into pressure port, being careful not to over tighten.

5.  After installation, start engine and check all connections for leaks.

For service send your product to Auto Meter in a well packed shipping carton. Please include a note explaining what the problem is along with your phone number. Please specify when you 
need the product back. If you need it back immediately mark the outside of the box “RUSH REPAIR,” and Auto Meter will service product within two days after receiving it. ($10.00 charge will be 
added to the cost of “RUSH REPAIR.”) If you are sending product back for Warranty adjustment, you must include a copy (or original) of your sales receipt from the place of purchase.

12 MONTH LIMITED WARRANTY

Auto Meter  Products, Inc. warrants to the  consumer that all Auto Meter  High Performance products will be  free from defects in material  and workmanship for a period  of twelve (12) months from  date of the 
original purchase. Products that fail within  this 12 month warranty period will be repaired or replaced at Auto Meter’s option to the consumer, when it is determined by Auto Meter Products,  Inc. that the product 
failed due to defects in material or workmanship.  This warranty is limited to the repair or replacement of parts in the Auto Meter instruments. In no event shall this warranty exceed the original purchase price of 
the Auto Meter instruments nor shall Auto Meter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the failure of this product. Warranty claims to Auto Meter 
must be transportation  prepaid and accompanied with dated  proof of purchase. This  warranty applies only to the original purchaser of product  and is non-transferable.   All implied warranties shall be limited in 
duration to  the said 12  month warranty period. Breaking the instrument  seal, improper use or installation,  accident, water damage, abuse, unauthorized  repairs or alterations voids this  warranty.  Auto  Meter 
Products, Inc. disclaims any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by Auto Meter.

   SERVICE

FOR SERVICE SEND TO: AUTO METER PRODUCTS, INC. 413 W. Elm St., Sycamore, IL 60178 USA  [phone]

Email us at [e-mail]

Use Teflon Sealing Tape Or Sealing
Compound On Pipe Threads.

© 2001 Auto Meter Products, Inc.                2650-509           3/28/01