

 Do not unplug valves while on!
  ValveLink8 controller = 12 V AC up to 2.4 Amps @ 50-60 Hz

barrel Perfusion Pencil, Chromatography, Gel/Blot washing
 System, Faulty valves, Leaks, Replacing valve  ttings, 

ValveLink Laboratory Applications
been built into the ValveLink for advanced perfusion use.
busy lab countless hours of tedious monitoring.
 ma tog ra phy runs with excellent reproducibility. The ValveLink 
be controlled by digital TTL* signals from any I/O card or device.  

 ning cleaning solutions and drying your 
 fu sion rig - from AutoMate, 
For Single-cell or Whole-cell Superfusion
 o my per fu sion systems, Lure-lock 

, use a short piece of 1/16” 
barb (cut as desired, but see note 

bath for temperature control.

buttons between control of two ‘banks’ of eight valves. 
barbs to reservoir nipples.

bits 0-3 from both ValveLinks to your digital output. Bits 0-2 decode 

binary number if the fourth TTL Input is low. Turns off mode 1.
 pat i ble with the one offered by Axon In stru ments. All com mands 
begin with ATn, where n is a single digit from 0-9, indicating the 
be ter mi nat ed with a car riage return <cr>. Possible commands are:

be disconnected before completely empty. Simply loosen the luer 
, and remove the syringe and stopcock to-
be some distance away. The micro-manifolds available from Auto-
bore tubing, although this may also reduce  ow rate re sult ing in the 
bore use. Also see the micro-manifold instructions on page 7.

be rejuvinated by simply prying them open. First energize (turn 
be tween the heavy black cable and the valve lead wires – under the 
best efforts and pursuit of high quality valve manufacturers, some 

back into the valve. Be sure not to use too much glue or tape, as 
Valve returns & Replacing a Valve
bottom of the sheath, the offending valve’s cable from the plug end 
 as long as you include a note with the following:
broken here, inside the next piece of elec tri cal tape 

back to AutoMate. International (or busy U.S.) customers will be