Auto Mate 477A User Manual
Replacement Transmitter
High Frequency, Stealth Code Remote
PP//NN 447777AA
Compatible with the
following systems:
AAuuttoommaattee AAMM 99
MADE IN TAIWAN
©2003 Directed Electronics, Inc. Vista CA 92081
All rights reserved.
P/N 477A 06/04
REPLACEMENT TRANSMITTER
Model 477A, 5 Button HF, Stealth Code Remote
The following Learn Routine can be used to program
this replacement transmitter to the system. In order to
enter the Learn Routine, the system’s Valet/Program
switch must be plugged into the BLUE port.
1. Door. Open a door.
2. Key. Turn the key to the ON position.
3. Choose. Within 5 seconds press and release the
Valet/Program button the number of times corresponding to the desired channel listed below.
Once you have selected the channel, press the
Valet/Program button once more and hold it. The
LED will flash the same number of times as the
channel selected and the siren (if connected) will
chirp to confirm the selected channel. Do NOT
release the button.
4. Transmit. While holding the Valet/program
button, press the button from the transmitter you
wish to assign to that channel. The unit will chirp
(if horn or siren connected) to confirm that the
transmitter has been taught to the receiver
5. Release. Once the code is learned you can release
the Valet/Program button and remove the key.
Standard Configuration
A remote that has been programmed to an standard
configuration will use separate buttons for arm and
disarm similar to a factory keyless entry. Using the
expanded configuration, the transmitter buttons are
assigned to the following functions:
Lock Icon Button
The lock icon button arms and locks the system.
Unlock Icon Button
The unlock icon button disarms and unlocks the system.
AUX Icon Buttons
The AUX icon button operates channel 2.
Siren Icon Button
The siren icon button operates Panic only.
Unlock and Lock Icon Buttons
When pressed together, the lock and unlock icon buttons operate channel 3.
FCC/ID Notice
This device complies with Part 15 of FCC rules.
Operation is subject to the following conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.
CAUTION! Changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate this device.
93207
00314
1
0
Channel Number Function
564 Platform 554 Platform
1 8 Auto-learn Standard Configuration
2 9 Auto-learn Single-Button Configuration
11 10 Delete All Transmitters
Loading...