Autocue Digital Cue Light Kit User Manual
Sensor Mounting
Cue Light Controls
8. Attach the self-adhesive
Velcro disc to the on camera
tally and secure the sensor to
the disc.
A
Note: If there is not a camera tally light available, the tally
output socket that is fitted to most cameras can be used.
Remove the sensor head and fit compatible plug. (The two
conductors in the sensor cable need to be shorted to make
the cue light operate)
Note: This step is not
required if the unit is
connected to the Tally
out socket.
10. The Trim Control adjusts the sensitivity of the sensor.
To set the level ensure that the on camera tally light is on
and the sensor is in place. Rotate the control clockwise
until the display changes from green to red. The sensor is
now set.
Digital Cue
Light Kit
Guide
9. Plug in the power cable into the sensor socket. This will
provide power to the cue Light. This socket is only available
on the MSP range of monitors.
For use with the PSP range of monitors an additional 12V
DC power supply will be required.
11. Rotate this control until the desired camera
number is displayed.
Connector Specifications
Socket Pin out Note
Power Input Pin 1- / Pin 6+ 12v DC / 0.02mA
Sensor Input Pin 1 and 2 Short for operaon.
autocue.com
Components
(A)
(B)
(D)
(C)
Sensor Unit
A
B Power Cord
Velcro Disc
C
Cue Light
D
2. Secure the Cue Light to the hood frame retainer
using the small thumb screw provided.
5. In operation the Cue Light display changes
colour from green to red when the sensor unit
sees the camera tally light change.
Assembly
(A)
(B)
1. Remove the knob (A) and catch plate (B) from the
hood frame Retainer.
3. Replace the catch plate and knob.
4. Re-secure the hood frame retainer. The Cue Light is
now mounted to the hood.
6. To install the sensor, plug the unit into the
socket marked sensor.
7. To supply power to the Cue Light, plug the
power cord into the socket marked 12V DC.
Loading...