Authinx FWKR, FWIR Users manual
INSTRUCTION MANUAL
Cat. No. FWSK
HHHHoooommmmeeee AAAAuuuuttttoooommmmaaaattttiiiioooonnnn SSSSttttaaaarrrrtttteeeerrrr KKKKiiiitt
tt
Indoor Remote
Catalog # FWIR
Messenger Hub
Catalog # FWMH
Lamp Receiver
Catalog # FWLR
Key Chain Remote
Catalog # FWKR
Bulb Receiver
Catalog # FWBR
Home Auto Manual large NEWEST 4/24/03 3:40 PM Page 1
6
7
5
8
9
10
11
12
13
14
ON OFF
ROOM COLOR
ON
OFF
ON
OFF
4
3
1
16
15
ON
ON
OFF
OFF
ON
MOOD 2MOOD 1 HOUSE
ON
OFF
OFF
2
General Safety Rules
WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious
personal injury.
SAVE THESE INSTRUCTIONS
CAUTION: To reduce the risk of electric shock, do not disassemble any parts. No user-serviceable parts are inside. If you spill liquid on a
unit, disconnect the unit from the AC outlet to prevent possible fire or shock hazard and consult authorized service personnel.
WARNING: To prevent electric shock hazard, do not expose any part to rain or moisture.
WARNING: Use only incandescent bulbs in lamps that are to be controlled by Lamp Receivers. Using any other type bulbs could damage
bulbs and or Lamp Receivers. Attempting to control any other device by the Lamp Receivers, may damage that device and may damage the
Lamp Receiver.
FCC Caution
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECTTO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MA YNOT CAUSE HARMFULINTERFERENCE, AND
(2) THIS DEVICE MUSTACCEPTANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This equipment generates and uses radio frequency energy, and if not installed and used properly, that is, in strict accordance with the
manufacturers instructions, it may cause interference to radio and television reception. It has been type tested and found to comply with the
limits for remote control devices in accordance with the specifications in Sub Parts B and C of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause interference to radio or television reception, which can be determined by unplugging the equipment, try
to correct the interference by one or more of the following measures.
• Reorient the antenna of the radio/TV experiencing the interference.
• Relocate the interference with respect to the radio/TV.
• Move the interference away from the radio/TV.
• Plug the interface into an outlet on a different electrical circuit from the radio/TV experiencing the interference.
• If necessary, consult your local Dealer for additional suggestions
NOTE: Modifications to any of the components in this kit will void the user’s authority to operate this equipment.
2
Home Auto Manual large NEWEST 4/24/03 3:40 PM Page 2
3
INDOOR REMOTE
LAMP RECEIVER
BULB RECEIVER
MESSENGER HUB
KEY CHAIN REMOTE
The MESSENGER HUB is the brain of the Freewiretmsystem. When it is plugged into an AC
outlet it has the ability to receive Radio Frequency (RF) signals from the remotes and the
ability to send messages through existing house wiring to all receivers that are dialed to the
same house code.
It is also used to control *incandescent lamps only
, rated up to 500 watts, connected to the
plug receptacle at the bottom of the MESSENGER HUB. Note: For restrictions and
instructions see MESSENGER HUB section.
*Do not use fluorescent, low wattage, energy saving and halogen bulbs.
The INDOOR REMOTE sends Radio Frequency (RF) signals to the MESSENGER HUB.
These signals can go through walls, so you can use this remote to control lights (or
appliances with approved appliance receiver only) from anywhere in or around your home.
NOTE: Walls and other obstructions may reduce the effective range of the RF signal.
A LAMP RECEIVER must be used in conjunction with at least one active MESSENGER
HUB. It is used to control *incandescent lamps only
rated up to 300 watts. Note: For
restrictions and instructions see LAMP RECEIVER section.
*Do not use fluorescent, low wattage, energy saving and halogen bulbs.
The BULB RECEIVER must be used in conjunction with at least one MESSENGER HUB. It
is used to control an indoor or outdoor incandescent light (up to 150 watts) that is normally
controlled by a wall switch.
*Do not use fluorescent, low wattage, energy saving and halogen bulbs.
The KEY CHAIN REMOTE can conveniently turn on and off a limited number of lights which
you select from the MESSENGER HUB. NOTE: For restrictions and instructions see KEY
CHAIN REMOTE section
Getting familiar with your
home automation kit.
Home Auto Manual large NEWEST 4/24/03 3:40 PM Page 3
10
11
12
ON OFF
ON
OFF
ON
OFF
7
8
9
13
14
ROOM COLOR
MOOD 2MOOD 1 HOUSE
6
5
4
3
2
1
16
15
ON
ON
OFF
OFF
ON
ON
OFF
OFF
Loading...