Aurum Electronics AEC711C User Manual

AEC-711C Wireless Handheld Screen Receiver

I. OVERVIEW OF AEC-711C

LCD/TV Button

LCD

MENU Button

OK Button

Channel Button

Buzzer

II. ASSEMBL Y INSTRUCTION

Antenna

LED indicator

Power switch

Video Output

View Button (1/4)
(Single/Quad)

Power Socket

Holder

Battery case

Rechargeable
battery (inside)

1. Install 3pcs NI-MH rechargeable batteries to the battery compartment with its polarities
matched.

Note:

- This receiver can also be powered on by adapter (DC 6V 1.5A).

- The rechargeable battery will be charged after the adapter is plugged in, and the charge

indicator lights up during charging and will turn off after a full charge.

- A full charge will take about 6 hours, which can power the receiver for about 4 hours

continuously.

- You are recommended to have the battery fully charged before its first installation to optimize its life.

- Do not burn or disassemble the rechargeable battery.

- Do not short-circuit the battery, it may cause fire or electric shock.

2. Push the power switch to ON position.

3 . Set the channel of receiver same as that of fitting by pressing the channel button continuously, and the pictures

are displayed on the monitor/TV.

- Press “MENU Button” then press Channel Button to select “MONITOR” and press “OK button”.

- Press “Channel Button” to select ”Pair Cam” and then press “OK button”.

- There is ”1 2 3 4” shown on the LCD, to select which number of channel you want to set up this fitting. Within 10 seconds, press

“Channel Button” to select the number of the channel you want then press ”OK button”. Within 10 seconds, press the “Dip
Switch” on the fitting and when you see detecting image displayed on the LCD, it means the channel setting is completed. If it
shows “No Connection”, repeat these steps again.

- For other three different fittings, repeat the above same steps to set up the different channel. Press ”View Button” for Quad View

condition, you can see 4-split view from 4 different fittings.

NOTE: 1. When you make the channel setting, LCD must be under “Single View” condition.

2. Before setting the channel between the fitting and LCD, press “Push-button” switch on the bottom of the fitting firstly,

the stepper motor will stop working (the RED LED will keep flashing) in order to keep “Dip Switch” on the fitting not moving
and can be easily pressed when setting up the channel later.

4. For more clear pictures or record image:
1

○

Please connect the receiver to a TV with video cable.

2

○

Please connect the receiver to a TV and a video recorder with video cable.

○2

1

○

III. OPERA TION

When AEC-9331C detects any movement, wireless LCD monitor is triggered for 30/60 seconds image at the same time.
The unobstructed transmission effective range is about 80 meters, but actual transmission range may vary according
to weather, location, interference and building. One wireless LCD monitor is possible to receiver 4 camera image.

LCD/TV Button