Aurora AU-LED0635CC, AU-LEDD3510, AU-LED09T, AU-LED09IP, AU-LEDD16CC Instructions Manual

V

LOW VOLTAGE 350mA CONSTANT CURRENT LED DRIVERS

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION

LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER FOR FUTURE REFERENCE

IMPORTANT INSTALLATION INFORMATION

Installation should be carried out in accordance with the latest edition of the National Wiring Regulations. If in doubt consult a qualified electrician.

x

For use with Aurora constant current LED products.

x

IMPORTANT Constant current LED Fittings MUST be wired in SERIES ensuring correct polarity. Failure to do so can cause permanent luminaire and/or

x

driver failure.
Insure that ALL electrical connections are tight with no loose strands.

x

Use the table below to assist with calculating how many LED fittings may be used with the constant current LED Driver. Simply multiply the number of

x

fittings by their respective wattage up to the MAXIMUM rating of the Driver. It is possible to combine different constant current fittings.

LED Driver Cat.No. Dimmable Wattage of LED’s Notes

AU-LED0635CC No 1-6

AU-LED09T No 1-9

AU-LED09IP No 1-9 IP68 rated

AU-LEDD16CC Yes 1-18 (2x9) 1-10V dimming, AU-DSPLED

AU-LEDD3510 Yes 1-10 240V dimming, AU-DSP251

AU-LEDD3516 Yes 10-16 240V dimming, AU-DSP251

INSTALLATION INSTRUCTIONS
Isolate from the mains supply before installation or maintenance.

1. The 350mA Constant Current Drivers feature loop-in and loop-out primary wiring terminals.
Black/Blue – Neutral Red/Brown – Live Green & Yellow – Earth.

2. Constant Current LED’s must be wired in series ensuring correct polarity, see Figure 2. Failure to do so may result in permanent damage to the lamp or
driver

3. The AU-LEDD16CC dimmable when used with AU-DSPLED 1-10V Dimmer Switch. For use with 350mA 1W LED’s. See Figure 3.

4. The AU-LEDD3516 and AU-LEDD3510 are dimmable when used with AU-DSP mains voltage dimmers, de-rate by 50%

5. The AU-LED09IP is IP68 rated to maximum 2m, use a suitable IP68 rated junction box for connection.

Fig.1
CORRECT Installation
Keep the LED Driver away from direct sources of heat such as Low

oltage lamps

INCORRECT Installation
Do not fit the LED Driver above the luminaire

Aurora Limited 16 Alban Park Hatfield Road St Albans Hertfordshire AL4 0JJ United Kingdom

Website: www.auroralighting.com

Document version – AU-LED_350CC_KY_V1_14_ENG&FRE

Fig.2 Series wiring for Aurora 350mA constant current LED’s
Constant Current LED Luminaires

Constant Current
LED Driver

Fig.3 AU-LEDD16CC Dimmable LED Driver

Example Wiring Diagram

Environmental Protection (W.E.E.E.) – Aurora’s WEEE Reg.No. WEE/BG0130YX (UK Only)

Waste Electrical & Electronic Equipment Regulations (WEEE) requires that any of our products showing this marking (left) must not be disposed of with

Warranty

See www.auroralighting.com for full details of warranties and Extended Warranty Terms and Conditions. The warranty is invalid in the case of improper
use, tampering, and removal of the Q.C. date label, installation in an improper working environment or installation not according to the current edition of
the National Wiring Regulations. Should this product fail during the warranty period it will be replaced free of charge, this is subject to correct installation
and return of the faulty product. Aurora does not accept responsibility for any installation costs associated with the replacement of this product. This
warranty is in addition to the statutory rights in your country of purchase. Aurora reserves the right to alter specifications without prior notice.

other household or commercial waste. Aurora does not levy any WEEE disposal charges to its customers for affected WEEE related products.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate any such product from other
waste types and recycle it responsibly at your local facilities. Check with your Local Authority, Recycling Centre or retailer for recycling advice.
If, when you purchased any Aurora product, your supplier included a WEEE disposal fee, you should then contact your supplier for advice on
his takeback of the product for the correct disposal.