Aurender W20SE Hardware Installation Manual
W20SE Hardware Installation Guide
3 41 2
5 6
1.
On/Off/Standby
2.
AMOLED Display
3.
Display Menu
4.
Play/Pause
5.
Play Previous
6.
Play Next
1
1.
AC Power Switch
2.
AC Power Socket
3.
USB Audio Class 2.0 Output
4.
AES/EBU XLR Output 1
5.
AES/EBU XLR Output 2
6.
Optical Output
2
3 4 5 6 7 8 9
10 11
7.
Coaxial RCA Output (SPDIF)
8.
Coaxial BNC (SPDIF) Output
9.
Coaxial BNC Word Clock Input
10.
USB 2.0 Data Port 1
11.
USB 2.0 Data Port 2
12.
Gigabit Ethernet Port
12
www.aurender.com
Customer Service: support@aurender.com
Aurender America Inc. / 63 Brixton, Irvine, CA 92620, USA
STEP 1: Connect to Power
Using the included power cable, connect your Aurender to 110V/120V or 220V (depending on your
region) electrical outlet or a power conditioner/surge protector.
STEP 2: Connect to Local Area Network (LAN)
Your Aurender server must be connected to your router via a hard-wired Ethernet connection.
Aurender servers do NOT have any WiFi connectivity (this is by design as most WiFi networks are
unreliable and subject to drop-outs and limited bandwidth).
In cases where your listening room location makes it physically impossible to run an Ethernet
connection back to the router, you might consider using a WiFi extender or ethernet-over-powerline
adapter to establish connectivity. Please contact Aurender Support for assistance.
Below is a diagram of a common connection schematic. Your network configuration may vary:
Note: Your Aurender is supplied with a generic IEC power cable. However, many Aurender
users choose to use an upgraded power cable for enhanced performance. Please consult your dealer
for cable recommendations.
STEP 3: Connection to Main Amplifier or Preamplifier
Using the included power cable, connect your Aurender to 110V/120V or 220V (depending on your
region) electrical outlet or a power conditioner/surge protector.
Speaker Speaker
Router
NAS
iPad
Aurender W20SE
Master Clock (optional)
DAC
AMP
Loading...