Aurelia Graphica User Manual

aurelia

User Manual

graphica

Congratulations on your excellent choice of loudspeaker!

We hope that you will have a great deal of happy audio

moments with your Aurelia Graphica loudspeakers for

many years to come!

We recommend that you carefully read the user manual

through and follow the guidelines which are provided.

This will ensure that the installation and first use of the

loudspeaker will be both simple and easy.

Thereafter, you will be able to confidently switch your

sound reproduction equipment on and enjoy an

unprecedented quality of sound.

Installing a stand

The loudspeakers are supplied with stand plates which can be
attached to the loudspeakers using the screws which are provided
in an equipment bag. The aforementioned equipment bag contains
the following:

- Attachment screws 12 pcs

- Platform sleeves 12 pcs

- Pieces of felt 12 pcs

The stand plate is attached to the bottom of the loudspeaker as
shown in Figure 2. At the beginning, there is good reason to place the
loudspeaker on its side on supports, so that the stand plate can be
easily attached to the base of the loudspeaker. The stand plate is
attached by the following stages:

1. Remove the pieces of felt from the Velcro band and attach them to
the base of the stand plate at the marked locations (see Fig 1). Each
base plate should have six pieces of felt.

2. Insert the screws (6 pcs), into the screw holes, located on the
bottom of the stand plate.

Fig 1. Attaching the pieces of felt

3. Place the platform sleeves to each screw on the upper side of the
plate.

4. Adjust the screws into the holes on the base of the loudspeaker and
screw them first, hand tight, to the bottom of the loudspeaker. The
holes on the base of the loudspeakers are pre-machined for M5
threaded stand attachment.

5. Finally, the screws are tightened, using a cross-point screwdriver
(Phillips). IMPORTANT! Avoid excessive tightening of the screws.
Excessive tightening may damage the threads on the base of the
loudspeakers.

6. Place the loudspeaker in the upright position and move it to the
listening location. IMPORTANT! Never lift a loudspeaker by its reflex
tubes.

Fig 2. Installing the stand plate