Installation Guidelines
™
Elite Pro Systems
EPS-112
T
Congratulations on purchasing an EPS-112T™ System from Auralex® Acoustics. You’re
now on your way to creating a world class listening environment.
Elite Pro Systems offer a sophisticated look by utilizing products covered with specialized
acoustical fabrics. The EPS-112T system contains both B22 ProPanels™ and CT45 Bass
Traps™, which when used together, provide incredibly effective broadband absorption in
any room. Use the EPS-112T alone for treatment of small to medium-sized rooms or in
combination with other Auralex products for full control of larger spaces.
Thank you for Purchasing Auralex
®
Total Sound Control
Elite Pro System EPS-112T Components
20
B22 ProPanels
™
CT45 Bass Traps
4
®
Products!
80
™
Impaling Clips
1
Tubetak Pro
846 -606 | Rev. 1 | 070 506 EF
™
Elite Pro System EPS-112T General Information
Marked panel
outline
TIP
CAUTION
Recommended Additional Installation Materials
• Power Drill • Tape measure
• Carpenters Level • Small ladder (depending on ceiling height)
• Pencil • 16 2.5” 4D finish nails
• Straight Edge • 160 .75”-1” drywall screws
• Nail Set • Hammer
B22 ProPanel Installation Guide
Mark intended location of each B2 2
➊
ProPanel on the wall or ceiling.
Start the B22 ProPanel 5/8” above its intended
➌
final height and press downward at a 45° angle
until the panel is flush with the wall or ceiling
surface.
Install four impaling clips within marked B22
➋
ProPanel location using drywall screws. Exact
placement of each clip is not necessary.
For permanent mounting, apply Tubetak Pro
adhesive to the back of the B22 ProPanel
before completing Step 3.
Always use Tubetak Pro on the back of the
panel when attaching it to the ceiling.
CT45 Bass Trap Installation Guide
16.75”
Mark a vertical line 16.75” from the intended
➊
placement corner on both sides.
While continuing to hold panel in place, install
➌
one finish nail though the fabric face and the
hardened edge of the CT45. Do not hammer
nail completely flush with the face of the panel.
Make sure finish nail is installed perpendicular
to the wall surface. Repeat in each of the four
corners.
Hold CT45 Bass Trap in corner with edges
➋
aligned to the marked vertical lines.
Using a nail set or another finish nail, carefully
➍
countersink installed nail so its head goes
through the fabric surface of the CT45 but not
through the hardened edge.
Once the finish nail has been countersunk into
➎
the panel, there may be a small hole remaining
in the fabric covering. Simply scrape the fabric
in this area with your fingernail and the hole will
completely disappear.
Elite Pro System Installations
See the Auralex® Acoustics website, www.auralex.com, for more information
about these and other Total Sound Control® products.
These are general recommendations. Should you have any additional questions about the installation of your
Elite Pro System, feel free to contact an Auralex® Application Specialist
via email at appsupport@auralex.com or call 1-800-95-WEDGE.
Loading...