Page 1
™
Tubetak Pro
USER GUIDE
DIRECTIONS:
To assure positive adhesion, surfaces must be clean, dry and free
of foreign materials.
New drywall must be primed and painted.
Cut the tip off the threaded nozzle feature on the
front of the tube and screw the application nozzle onto the tube.
Cut approximately 1” off of the tip of the application nozzle, at an
angle.
Apply a continuous bead of adhesive to the back of the foam about
1-1½” from the edges, then apply an X or zigzag in the center (see
Fig. A). The application pattern shown in Figure B will use more
adhesive but is more effective on surfaces that are difficult to
adhere to.
For best adhesion, align and carefully press your foam into place,
applying moderate pressure for a minimum of 15 seconds to
spread out the adhesive.
Separate the foam from the wall for 2 to 5 minutes then
reassemble with firm pressure.
Tubetak Pro is considered a permanent installation. Removing
the panel after the adhesive has cured can result in some damage
to the Studiofoam and the mounting surface. Try using a sharp
knife to carefully separate the panel from the adhesive to minimize
tearing. Use a citrus based adhesive remover to clean the adhesive
from the wall. Auralex is not responsible for any damage to walls,
the ceiling or the overall structure that occurs during installation or
removal of our products.
CURE TIME:
• Open Time: 13-18 minutes
• Firm Set: 1-2 Hours
Fig. A
• Handleable: 16 Hours
• Full Cure: 48 Hours
• Service Temperature Range: -13° F
• (-25° C) to 158° F (70° C)
Fig. B
1-800-959-3343 / 317-842-2600
9955 Westpoint Drive, Suite 101, Indianapolis IN USA 46256
1028-6 13.Tubetak Pro User Guide 20 13.indd (Jul y 23, 2017 12:38 P M)
Loading...