Auralex ProGO Caster Kit User Manual

ProGO-26™ & ProGO-44™ Caster Kit

ASSEMBLY / USER GUIDE

Thank you for purchasing the Auralex® ProGO-26 - 44 Caster Kit.

ProGO-26 Caster Kit (one base required)

(2) Locking casters

(2) Non-locking casters

(16) #10 x ¾” wood Screws

ProGO-44 Caster Kit (two bases required)

(2) Locking casters

(4) Non-locking casters

(24) # 10 x ¾” wood screws

TOOLS NEEDED: #2 Phillips screw driver. A power driver with adjustable clutch is recommended. Start with a lower
clutch setting to avoid stripping screw heads or the wood panels!

NOTE the five sets of pre-drilled caster mounting holes on the bottom of

the ProGO base

ProGO-26: Using the supplied wood screws, install the casters as shown
below with a locking caster at each end of the base

ProGO-44: Using the supplied wood screws install the casters as shown
below with a locking caster at the outboard end of the base.

Duplicate this caster installation for the other base in the pair.

Outboard end Inboard end

Outboard end of base with two casters

Inboard ends of bases

with single casters

ProGO I nstalla tion Guid es.indd (July 25, 2 013 10:41 AM)