Thank you for buying our August TV. You may already be familiar with using
a similar product but please take time to read these instructions carefully. It is
designed to familiarise you with the product’s many features and to ensure
that you get the very best from your purchase.
To ensure your safety and the safety of others, please ensure you read the
Safety Instructions before you use this product.
Please ensure the product and its accessories are disposed in compliance with
WEEE (Waste Electrical and Electronic Equipment) Directive and other
regulations. Please check with your local authority for disposal regulations.
If you need help, please contact our Customer Service:
Telephone: +44 (0) 845 250 0586
Email: service@augustint.com
Safety
Disposal
Customer Service:
User Manual
Quick Start Guide
DA900C
It is suggested that you use a roof top aerial when scanning for TV channels
for the first time, if any signal is detected, the channel information will be
saved on the TV, you may then switch back to the portable antenna supplied
and change your location to find the best place to receive the signal.
Connect the device to the mains power, press POWER on the remote to
turn on the device, or press and hold POWER on the device for 1.5 seconds
to turn it on.
The MODE on the device or remote allows you to switch between: DTV
(Digital Freeview TV & Media Player), ATV (Analogue TV), AV IN,
BRIGHTNESS, CONTRAST, COLOR, SCALE (Aspect Ratio) and
INVERT.
When turning on the device for the first time, “Initial Install” will show,
follow the instructions to select OSD Language and Area, then press
ENTER, it will ask whether to install, select YES, the auto search will then
start. Once the search has finished, press CH+, CH- or EPG to select
channels. Press TV/R to switch between Freeview TV and Radio channels.
If you have done the first time installation before, and would like to search
for Digital Freeview channels again, or if you have moved to a different
region and need to scan channels again, press MODE to switch to Digital
TV & Media Player mode, press MENU, select “Digital TV” by pressing
ENTER, select “Installation”, then select “Auto Search”, press ENTER to
start the search. Once the search has finished, press CH+, CH- or EPG to
select channels. Press TV/R to switch between Freeview TV and Radio
channels.
To search for Analogue TV, press MODE repeatedly until it shows ATV,
press LEFT or RIGHT to switch to the Analogue TV mode. Press MENU, it
shows the ATV SETUP menu, set the TV FORMAT to “PAL I” for UK,
then move to AUTO SEARCH, press ENTER to start the search.
1.
2.
3.
4.
5.
6.