VX-5
HAND-HELD VOCAL
CONDENSER MICROPHONE
overview
The VX-5 is a stylish and innovative hand-held vocal condenser microphone designed to handle a wide variety of
live, studio and broadcast applications.
With a smooth frequency response of 40 Hz - 16.5 kHz
(plus or minus 3 dB), the VX-5 features a 14mm gold
vapor diaphragm, a supercardioid polar pattern, a -10 dB
pad, a bass roll-off filter, an acoustically ported steel
mesh grill screen, and a rugged die cast zinc body.
The VX-5 will handle sound pressure levels in excess of
140 dB (in the pad and roll-off position) without distortion and will additionally provide over 20 dB of ambient
noise rejection for feedback control on live stages.
The VX-5 operates on phantom power of 9-52 volts and
will achieve optimum results when used with a high quality mic preamp. In addition to vocal applications, the VX-5
is ideally suited to capture acoustic instruments such as
guitar, woodwinds, brass, percussion toys, and drum overheads. and hi-hat.
applications
g
Lead vocals
g
Background vocals
g
Speech
g
Acoustic instruments
specifications
Transducer Type
Electret
Condenser
Frequency Response
40 Hz-16.5 kHz ± 3 dB
Polar Pattern
Supercardioid
Output Impedance 150 Ohms
Open Circuit Sensitivity
6.9 mV
(ref 1k @ 1 Pascal)
Equivalent Noise Level 26 dB (A weighted)
Signal to Noise Ratio 68 dB
(ref 1k @ 1 Pascal)
Off axis rejection >20 dB
Maximum SPL
>140 dB (w/-10 pad)
Cable/Connector 3 pin gold
plated male
XLR connector
Polarity Positive voltage on pin
2 relative to pin 3 of
output XLR connector
Housing Die cast zinc
Weight 8 oz / 227 grams
Finish Black E-coat
Choir
Flute
Strings
Lead
Vocals
Acoustic
Guitar
Ensemble
Vocals
features
g
Extremely smooth and accurate response
g
Perfectly balanced for handheld use
g
-10 dB pad and bass roll-off
g
Handles high sound pressure levels
g
Excellent gain before feedback
g
Low handling noise
g
Pop resistant grill
Audix Corporation 9400 SW Barber Street, Wilsonville, OR 97070.
® Audix Corporation 2006. All rights reserved. Audix and the Audix logo are trademarks of Audix Corporation.
CALL: 503-682-6933 FAX: 503-682-7114
www.audixusa.com
Specifications are subject to change without written notice.
The frequency
response chart
(above) and the
polar patterns
represent a typical
production run for
this microphone.
(in Millimeters)
Operation and Maintenance: Condenser microphones
as a general rule are much more sensitive and reactive
than dynamic microphones and should be handled
with care. Avoid extreme temperatures wherever
possible. Moisture and high humidity can adversely
effect the performance of the microphone and cause
permanent damage. For outdoor use consider using an
outer foam windscreen to help reduce wind noise or
popping. When not in use, please store your mic in
the pouch or case provided at room temperature.
-10 dB pad and Bass Roll-Off Switches: The VX-5
is equipped with dip switches that will allow you to
contour the sound and output level of the microphone. The switches are recessed and can only be
engaged by using a tool such as a mini-screwdriver
or the head of a ball point pen.
-10 dB pad: The pad is utilized in order to reduce
the output sensitivity of the mic. Following are
examples of where this might be helpful:
a) The vocalist has an extremely powerful voice
b) The vocalist likes to work right on top of the mic
c) The volume on stage is extremely loud
d) The instrument being miked produces very high sound
pressure levels
Bass Roll-Off: The bass roll-off filter is used to
eliminate frequencies below 150 Hz. Following are
examples of where this might be helpful:
a) More clarity of the vocal is desired
b) The PA system has subs
c) Effective way to help minimize bass frequencies being
produced by bass guitar, kick drum and other bass
producing instruments from bleeding into the vocal mic
Live Sound:
The VX-5 is designed to have minimal handling
noise and may be hand-held or used on a mic stand.
The VX-5 is highly sensitive and will accommodate
working distances of 1-12 inches from the performer’s mouth while maintaining a uniform
response. Depending on the instrumentation and
volume on stage, the vocalist may have to experiment to find the optimum working range with the
VX-5. For stage monitors, avoid pointing the back of
the microphone directly into the stage monitor.
Instead, set the microphone at a angle parallel to
the floor, putting the angle of the mic on a different
plane with the angle of the monitors.
Background vocals: For purposes of gain before
feedback and to avoid phase cancellation, the “3 to
1” rule applies: the distance between the microphones must be at least three times greater than
the distance between the mic and the performers.
This generally means having a distance of at least a
distance of 2 feet between microphones.
WARNING:
The VX-5 requires 9-52 Volts of phantom power to fully
charge the element. For this reason, DO NOT PLUG OR
UNPLUG THE MICROPHONE INTO OR OUT OF THE PA SYSTEM UNLESS THE VOLUME OF THE SYSTEM IS TURNED
DOWN. Failure to do so may result in a loud “popping”
noise sensation which could seriously damage the speakers in the PA system.
OUTPUT:
The VX-10 output is balanced across Pin 2 (positive)
with respect to Pin 3, with the shield connection to Pin
1. It is recommended to use a high quality microphone
cable with 3 pin XLR connectors.
SERVICE AND WARRANTY:
This microphone is under warrantee for a period of 1 year from
any and all manufacturing defects. Should your microphone fail
in any way, please contact the Audix Service department at
503-682-6933. A Return Authorization number is required
before sending back any products.
VX-5
HAND-HELD VOCAL
CONDENSER MICROPHONE
Typical Frequency Response
Polar Charts
Dimensions
30Hz
-10
10
0
20kHzFrequency in Hertz
Relative dB SPL
Supplied Accessories
g MC1 - High quality nylon mic clip adjustable
through 180 degrees with a standard 5/8
inch –27 thread.
(Note: metal adapter also sup-
plied to accommodate European standard threads).
g P1 - Cordura carrying pouch.
Optional Accessories
g
WS-357 External acoustic foam windscreen
g
SMT-25 Shockmount clip
g
APS-2 Two-channel phantom power supply
g
CASE-BP Aluminum carrying case
(holds 4 vocal microphones)
g
CBL-20 20' XLR-XLR mic cable
Loading...