Audiovox XTM-600 User Manual
Model AXTM-600
600 Watt Mono Block
MOSFET Amplifier
OWNER'S
MANUAL
INDEX
Specifications.....................................................................3
Precautions........................................................................4
Installation Instructions...................................................... 5
Wiring Instructions........................................................ 6 - 7
Input Wiring Diagram........................................................ 8
Output Wiring Diagram..................................................... 9
Operation.................................................................. 10 - 11
Warranty...........................................................................12
HIGH PERFORMANCE STEREO AMPLIFIER
This power amplifier has been designed to provide high Quality performance with a
minimum of maintenance. However, it's performance will only be as good as the care
and quality of components with which it is installed. We therefore advise that you
read these instructions very carefully to familiarize yourself with the product and it's
features.
Should you require assistance with the installation or wiring so this unit, please call
our toll-free "HELP" line at 1-800-645-4994 during the days/hours shown.
SPECIFICATIONS
HELP!
1-800-645-4994
Monday-Friday 8:30am - 7:00pm Eastern
Saturday 9:00am - 5:00pm Eastern
Maximum Output Power: 600 Watts
300 Watts RMS
@ 4 Ohms
Output Impedance: 2 - 8 Ohms (Mono)
Frequency Response: 10 - 30KHz. 1 dB
Signal / Noise Ratio: 90 dB
Input Impedance: Low-Level 10K Ohms
High-Level 100 Ohms
Input Sensitivity: Low-Level 200 mV - 8 V
High-Level 2V - 10 V
* Due to continuing improvement, Audiovox reserves the right to change features and design without notice.
Filter type: Selectable Full/Low-pass
Crossover @ 18dB/Octave
Filter Crossover: LPF 50-250 Hz (variable)
HPF 50-250 Hz (Variable)
Bass Boost Level: 0 - 18dB (Variable)
Bass Boost Frequency: 40 - 80Hz (Variable)
Supply Voltage: 12 volts, negative ground
Fuse Rating: 20 amps.
Dimensions (W X H X D): 295 mm X 54.3 mm X 230 mm
11-5/8" X 2-1/8" X 9”
-3-
PRECAUTIONS
1. Although this unit is designed with built-in self-protection circuits, there may be a possibility of damage if it is not wired
correctly. Please follow the wiring instructions carefully for the type of system being used.
2. The last lead to be connected is the wire to the positive( ) terminal of the battery. Connect this wire only after having
completed and checked all other connections to the amplifier.
3. By nature of its design, a power amplifier generates heat and requires good air circulation around it to dissipate that
heat. Do not install the amplifier in an enclosed area which does not permit adequate air circulation. Should the
temperature of the unit rise too high, the internal thermal sensors will shut off operation until it has cooled down
sufficiently.
4. If fuse replacement is necessary, use only fuses of the same ampere rating as originally supplied with the unit. The
use of fuses with incorrect ratings may cause serious damage to the amplifier. If fuses blow consistently, carefully
check all electrical connections to the unit.
5. Supply of adequate battery voltage is critical to the proper operation of the power amplifier. The leads to the battery
and chassis ground must be of a thick enough gauge to provide this voltage to the amplifier. We recommend #10 gauge
wire or thicker (smaller gauge #) for the battery and ground leads.
6. Make certain that the speaker(s) to be used with this amplifier are capable of handing the output power (wattage) of
the unit. Use of speaker(s) not rated for the output of this amplifier may cause damage to or failure of the speaker(s)
for which Audiovox will not be liable.
++
-4-
Loading...