Audiovox XMEXT50 Installation Manual

To install your XM-EXT50 please follow the instructions and illustrations listed below:

Step 1 Step 2 Step 3

Remove rubber boot as shown. Insert antenna's connector

through the rubber boot as illustrated and into amplifier's connector. Replace rubber boot.

Insert the cable's connector into the connector marked ANT or Antenna on the XM receiver or Plug & Play system.

Warning

DO NOT attempt to cut, splice or otherwise shorten the cable! Any remaining length should be carefully coiled.

DO NOT kink the cable. Avoid bending cable with a bend radius of less then 1 inch.

DO NOT expose the cable to severe environmental conditions. Care should also be taken to avoid direct and high moisture areas.

DO NOT link more than two extension kits.

invironment of XM Satellite Radio in any

• Extends the installation options

• Indoor/Outdoor

For use with all XM Satellite Radio Systems*

50' EXTENSION KIT

Step 1 Yes NoStep 2 Step 3

ANT

DC IN 6V

LINE OUT

Please mount amplifer upright as shown above.

Please refer to the XM-EXT50 user guide included with your receiver to complete your XM system set up.

Specifications

Cable Length

Cable Type

Frequency

Amplifier Gain

Return Loss

Connectors

50 feet

RG-58

2300 to 2400 MHz

10dB +/- 1 dB @ 2300 MHz

-10dB

SMB

Installation instructions printed on the inside of this card.

For additional information: Call 1.800.942.TERK (8375) or visit www.terk.com

For additional information about XM Satellite Radio service visit www.xmradio.com

Made in China

One year limited warranty

The XM name and related logos are trademarks of XM Satellite Radio inc.

TERK and TERK Technologies are trademarks TERK Technologies Corp. Commack, NY

136P003