Audiovox WHS200 User Manual

Parts supplied
1. IR transmitter (1)
2. IR Transmitter harness (1)
3. IR headphones (2)
INSTALLATION INSTRUCTIONS
WHS200
Stereo Headphone System
Fig. 1
TRANSMITTER
POSITION IN MIDDLE OF
TRANSMITTER POSITIONING DIAGRAM
FRONT
SEA TING AREA
TRANSMITTER
REAR
POSITION JUST ABOVE THIGH AREA OF SECOND PASSENGER
ROW SEATING
Notes:
• For best results, IR transmitter must be installed as shown with the LED’s pointing toward the rear of the vehicle (Fig. 1)
• Audio input can be connected to either a low-level fixed audio output or a variable level audio output (such as a speaker or headphone output). If it is connected to a low-level output, only the volume control on the headphones needs to be adjusted to control volume level. If connected to a variable level output, volume adjustment needs to be done at both the source and at the headphones.
Fig. 2
1. GROUND
2. WHITE
3. RED
4. BLACK
5. RED
WIRING DIAGRAM
CHANNEL A
1. LEFT RCA CHANNEL IN
2. RIGHT RCA CHANNEL IN
3. DC 12V GND – (NEGATIVE)
4. DC 12V IN + (POSITIVE)
1. GROUND
2. WHITE
3. RED
CHANNEL B
1. LEFT RCA CHANNEL IN
2. RIGHT RCA CHANNEL IN
Wire harness with RCA connectors (Fig. 2).
1. Using dual RCA (M/M) cable (not supplied, length determined by installation) connect one end to red and white
RCA jacks. Connect the other end to low level signal source.
2. Connect pin 4 (black wire, negative) to ground of vehicle.
3. Connect pin 5 (red wire, +12 volt) to ignition source (source that supplies +12 volts when the ignition is
switched on).
Fig. 3
ALWA YS FACE LEDs TOW ARDS REAR OF VEHICLE
CEILING OF THE CAR
SIDE VIEW
IN-CAR TRANSMITTER
TOP VIEW
IR Transmitter
1. Plug wire harness into transmitter.
2. Fasten transmitter to headliner using two short screws (make sure that screws do not puncture metal of roof).
Wireless headphones
1. Follow directions in owner’s manual for proper operation.
© 2000 Audiovox Corp., Hauppauge, N.Y. 11799 128-5831A
Loading...