Audiovox VSIR100W-B User Manual

Remote-Controllable Infrared Stereo Volume Control

Control volume of multiple sources remotely.

– VSIR100W/B

Features an d ch ar ac ter istics-

6. Set up to receive IR: Loosen the connector screws. Insert the corresponding wires. Then, tighten the screws.

- “ V+”

- “ G ”

- “IR ” - IR signal

- 12VDC power

- Grounding

• Infrared stereo volume control with selectable impedance matching (1x, 2x, 4x, 8x).

• Includes Decora™ insert and decorative faceplates in white or ivory.

• Power handling: 25 ~ 100 watts per channel RMS.

• Removable connectors accommodate 14- to 22-gauge wire.

• One- or two-side terminal connections.

Instruction

1. Remove about 1/4” of insulation from both ends of all wires to be connected

to the volume control. Twist the exposed strands.

Note: The removable connectors accept up to 14 gauge wire.

2. Loosen the set screws on the volume control.

3. Connect the leads from your amplifier to the volume control set screws

labeled INPUT. Make sure the LEFT L(+) and L(-) and RIGHT R(+) and R (-) wires are inserted in the appropriately marked opening. Then, tighten the

7. Mount the VSIR100 into wall box and screw on the face plate.

Volume set at maximum

Impedance jumper settings to match 8 at amplifier

SPEAKER OHMS () 1X 2X 4X 8X

8 1 PAIR 2 PAIR 4 PAIR 8 PAIR 4 - 1 PAIR 2 PAIR 4 PAIR

Impedance jumper settings to match 4 at amplifier

SPEAKER OHMS () 1X 2X 4X 8X

8 2 PAIR 4 PAIR 8 PAIR 16 PAIR 4 1 PAIR 2 PAIR 4 PAIR 8 PAIR

Jumper settings Assembly diagram

Mounting depth: 2.48” (63mm) from finished wall.

screws.

4. Connect your speaker wires to the volume control set screws labeled

OUTPUT, observing the + (positive) and - (negative) polarity of left and right speaker.

5. Set up the completed assembly in the junction box. Insert the assembly

carefull y to avoid exce ssive strain on the set screws. If necessary , pre-dress the wires.

(

Connection diagram

Remote – controllable IR

LEFT SPEAKER

OUTPUT

RIGHT SPEAKER

OUTPUT

volume control

VSIR100W/VSIR100B)

L+

INPUT

L-

R-

INPUT

R+

AUDIO SOURCE

Remote-Controllable Infrared Volume Control

VSIR100W/VSIR100B

Infrared Diode

Infrared Trans parent Housing

Self-adhesive

10 feet wire

12V 500mA

Caution

Do not allow speaker wire strands t o short out against the case or other speaker wires.

OWNERS MANUAL