Audiovox VBT100 User Manual

Power Input

12V DC

14 ~122 Fahrenheit

0 ~122 Fahrenheit

AC to DC 12V Adapter

1.9 X 5.9 X 1.0 Inch

0.35 Pounds

OWNER'S MANUAL

FORM NUMBER 128-6529

- EXTERNAL ANTENNA INPUT

- 1 A/V OUTPUT

- INPUT VOLATAGE 12V

- ELECTRONIC TUNING SYSTEM

- AC AND DC VOLTAGE ADAPTERS

(Improper handling may result in in injury.)

! Every connection should be tight and in the right direction for the best results.
! Dont' watch TV while driving.
! Avoid direct heat or moisture when installing this unit.
! To avoid an electric shock potential, do not attempt to service. Contact your
local service agency.
! Use the supplied AC adapter or car DC adapter.
! Install on the flat surface and unfold support bar.

TV TUNER PARTS

CONNECTING POWER

1. Connect the TV tuner to a monitor by
connecting cord to A/V out jack( ).

2. Connect to power source using AC
or car DC

3. Pull out the antenna rod( ) then rotate the rod
to find the best reception.

1. The "QUICK MEMORY" and "AUTO MEMORY"
function is a convenient function which allows you
to automatically tune in the available channels with
just one button.

2. To enable the QUICK MEMORY function, push
menu button( ) for 3~4 seconds. "QUICK
MEMORY" will be displayed on the screen. It will

take about 20 seconds to scan all channels.

3. Generally the quick memory function finds most of the available channels but
sometimes you need the "AUTO MEMORY" function for weaker channels. To enable the
"AUTO MEMORY" function, push channel up/down buttons( ) for 3~4 seconds. "AUTO
MEMORY" will appear on the screen. Channel scanning will take approximately 30~40
seconds.

adapter

(12V)( ).

adapter

CHANNEL UP AND DOWN
A/V OUT

UNFOLDING SUPPORT BAR

1. Before using the tuner, rotate the
support bar clockwise. Make certain
the unit is stable before extending
and rotating the antenna rods.

1. To add the channel manually, push menu button( ) two times, then "SKIP MODE-ON"
will appear on the screen. Push the channel up or down button( ) to change skip mode
from "ON" to "OFF". Push menu button( ) to exit menu. Select desired channels one
by one with channel up or down button( ). When you push the menu button( ), if the
channel is not a memorized one, "ADD CH-NO" will appear, otherwise "ERASE CH-NO"
will appear. Then push channel up or down button( ) to add or erase the channel
manually. Then push the menu button( ) again then up or down button( ) to set skip
mode "ON". Then press the munu button( ). When you finished, push channel up or
down button( ) to check the memorized channels.