Audiovox PRO 9649 User Manual 2

Model PRO 9649

Owner’s Manual

3 Button Remote Security System with

IMPORTANT !

system is equipped with selectable manual override circuitry. It is possible that you will need to
manually override your security system if the transmitter becomes lost, or inoperative due to
battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such situations.
In addition, the chart on the last page of this manual has a section for the particular features
and options installed in your vehicle as well as the override method selected.

manual override is pre-selected from the factory,

for "Custom Code" operation. Confirm the override mode selected on the last page of this
manual, and familiarize yourself with the selection on it's operation.

FEA TURES :

w 2 Three Button Programmable RF Transmitters (capable of accepting 4 transmitters)
w Five Channel Receiver
w Anti Code Grabbing Technology
w Selectable Manual Override Mode
w Remote Panic in all modes
w Protected Valet
w User Programmable Manual Override Code
w 7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
w Intrusion Alert with Memory
w Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w Instant Siren Activation
w Starter Disable
w True Last Door Arming ( hardwire only )
w Defective Zone By-Pass
w Hardwire or Voltage Sense Selectable
w Active or Passive Arming Selectable
w Programmable Auto Lock On / Off
w Programmable Auto Unlock On / Off
w Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
w Programmable Active or Passive Door Locks
w User Programmable Permanent Chirp Delete
w On Command RF Chirp Delete from Transmitter Or Selectable Through Software
w 6 Tone Multi Tone Siren (And or)
w Car Horn Activation for additional alarm response
w Additional Negative Trigger Input
w RF Inhibit with ignition on
w Parking Light Flasher
w Remote Trunk Release ( must have electronic trunk release )
w Remote Keyless Entry With Optional Access Guard ( must have power door locks )
w Illuminated Entry

OPTIONS :

w Multiple Vehicle Capable
w Headlight Illumination during Arming and or Disarming
w Remote Starter
w Remote Power Window Roll Up
w Remote Garage Door Interface
w Plug In Electronic Shock Sensor

Starter Disable, & Keyless Entry

In order to provide the highest possible level of security to your vehicle, this

Valet Switch

however, the system can be configured

YOUR " ANTI CODE GRABBING " TRANSMITTERS

The transmitters included with your new security system use the most advanced and secure form
of radio frequency transmission available on any current automotive security system. Some of
today’s sophisticated auto thieves use a device known as a code grabber, which will receive and
store the signal from your keychain transmitter, and re-transmit at a later time to disarm your
system.
Y our anti code grabbing transmitters will change their signal every time the button is pressed, so
when a thief grabs then re-transmits your signal, the alarm system
If your transmitter button is pressed more than fifty times while it is out of range of the vehicle
(children playing with your keys), the transmitter will not operate when you return to the vehicle,
and will need to be re aligned to the receiver. To do this, simply press the Lock button two times
within a one second time period. The system will now respond to that transmitter each time a
button is pressed.

ARMING THE SYSTEM - ACTIVE

1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.

2. Press and release the Lock button on the keychain transmitter.

SILENT ARMING - ACTIVE

1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.

2. Press and hold the Lock button on the keychain transmitter for 2 seconds.

ARMING THE SYSTEM - PASSIVE ( AUT OMATIC )

1. Turn off the engine, exit the vehicle, and close and lock all doors, hood lid, and trunk lid.

2. Opening any protected entry point during the 30 second passive arming cycle will immediately
suspend automatic arming, and the 30 second passive arming cycle will re-start when all doors
are closed. At the end of the passive arming cycle;

þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
þ Siren sounds one chirp.

If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection. If the siren did not
sound when arming, then the chirps have been turned off, and you should refer
to the section titled " ELIMINA TING THE ARM / DISARM CHIRPS " in this manual.

o Vehicles horn beeps one time.

If the horn beeps three times, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection. If the horn did not
sound when arming, then the chirps have been turned off, and you should refer
to the section titled " ELIMINA TING THE ARM / DISARM CHIRPS " in this manual.

þ Doors Lock
o Headlight Illumination - Optional

The vehicle’s headlights turn on for approximately 30 seconds, illuminating the
path as you leave the vehicle.

þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
þ Siren will not sound.

If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection.

o Vehicles horn will not beep.

If the horn beeps three times, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection.

þ Doors Lock
o Headlight Illumination - Optional

The vehicle’s headlights turn on for approximately 30 seconds, illuminating the
path as you leave the vehicle.

þ Red dash mounted LED begins to flash rapidly, indicating 30 second passive

arm i n g has begun.

þ Red dash mounted LED begins to flash slowly.

Page 2

will not

respond.

þ Parking Lights flash one time.
þ Siren sounds one chirp

If the siren did not sound when arming, then the chirps have been turned off, and
you should refer to the section titled "ELIMINATING THE ARM / DISARM CHIRPS"
in this manual.

o Vehicles horn beeps one time.

If the horn did not sound when arming, then the chirps have been turned off, and
you should refer to the section titled "ELIMINATING THE ARM / DISARM CHIRPS"
in this manual.

þ Doors Lock

Door locking during passive arming is a selectable feature. The alarm can be
programmed to allow the doors to lock only when arming using the keychain

PROTECTION WHILE THE SYSTEM IS ARMED

þ Opening any protected door, hood, or trunk lid will cause the alarm to immediately sound.

The alarm will continue to sound for 30 seconds, then stop and continue to monitor all
protected entry points. If the thief left a door opened, the alarm will sound for six 30
second cycles, remain armed, and ignore that triggered zone.

þ Whenever the system is armed, the red dash mounted LED indicator will slowly flash.

This serves as a visual deterrent to the potential thief. The LED is a very low current bulb,
and will not cause the vehicle’s battery to drain, even when left unattended for extended
periods.

þ Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30

second alarm cycle, attracting visual attention to the vehicle.

o Whenever the system is triggered, the vehicle’s horn will beep for the full 30 second

alarm cycle, attracting added attention to the vehicle.

þ Whenever the system is triggered, the interior courtesy lights will flash for the full 30

second alarm cycle.

þ Whenever the system is armed, the vehicle’s starting circuit will be bypassed. If the thief

should choose to ignore the siren, the vehicle can not be started.

o OPTIONAL Any strong impact to the vehicle’s glass will cause the alarm to trigger for the

full 30 second alarm cycle.

DISARMING THE SYSTEM

1. As you approach the vehicle, press and release the Unlock button on the keychain transmitter .

transmitter, and they will not automatically lock during passive arming.

þ Red dash mounted LED turns off.

If passive arming was selected during the installation, then the LED will start
flashing rapidly, indicating that the system is re arming automatically. Open any
door to suspend the automatic arming.

þ Parking Lights flash two times.

If the parking lights flashed three times, then the alarm was triggered in your
absence. Before turning the key on, examine the LED to identify which zone was
triggered.

þ Siren sounds two chirps.

If the siren sounds 4 chirps, then the alarm was triggered in your absence. Before
turning the key on, examine the LED and refer to the INTRUSION WARNING
SIGNALS section of this manual to identify which zone was triggered.
If the siren did not sound when disarming, then the chirps have been turned off,
and you should refer to the section titled "ELIMINATING THE ARM / DISARM
CHIRPS" in this manual.

o Vehicle's horn beeps two times.

If the horn beeps four times, then the alarm was triggered in your absence.
Before turning the key on, examine the LED and refer to the INTRUSION WARNING
SIGNALS section of this manual to identify which zone was triggered.
If the horn did not sound when disarming, then the chirps have been turned off,
and you should refer to the section titled " ELIMINATING THE ARM / DISARM

Page 3