Audiovox PRO 9644a User Manual 2
Model PRO 9644a
Owner’s Manual
3 Button Remote Security System with Starter Disable
IMPORTANT !
system is equipped with selectable manual override circuitry. It is possible that you will need to
manually override your security system if the transmitter becomes lost, or inoperative due to
battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such situations. In addition, the chart on the last page of this manual has a section for the particular
features and options installed in your vehicle as well as the override method selected.
Switch manual override is pre-selected from the factory,
configured for "Custom Code" operation. Confirm the override mode selected on the last page
of this manual and familiarize yourself with the section on it's operation.
FEATURES :
w 2 Three Button Programmable RF Transmitters (capable of accepting 4 transmitters)
w Separate Lock/Unlock Transmitter Buttons
w Five Channel Receiver
w Code Hopping Technology
w Selectable Manual Override Mode
w Remote Panic in all modes (Improved)
w Protected Valet
w User Programmable Manual Override Code
w 7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
w Intrusion Alert with Memory
w Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w Instant Siren Activation
w Starter Disable
w True Last Door Arming ( hardwire only )
w Defective Zone By-Pass
w Hardwire or Voltage Sense Selectable
w Active or Passive Arming Selectable
w Smart Disarming
w Programmable Auto Lock On / Off
w Programmable Auto Unlock On / Off
w Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
w Programmable Active or Passive Door Locks
w User Programmable Permanent Chirp Delete
w On Command RF Chirp Delete from Transmitter Or Selectable Through Software
w 6 T one Multi-Tone Siren, (And Or),
w Car Horn Activation for additional alarm response
w Additional Negative Trigger Input
w RF Inhibit with ignition on
w Parking Light Flasher
OPTIONS :
w Remote Trunk Release ( must have electronic trunk release )
w Remote Keyless Entry ( must have power door locks )
w Illuminated Entry
w Multiple Vehicle Capable
w Headlight Illumination during Arming and or Disarming
w Remote Starter
w Remote Power Window Roll Up
w Remote Garage Door Interface
w Plug In Electronic Shock Sensor
w Interior Illumination Upon Disarm
In order to provide the highest possible level of security to your vehicle, this
however, the system can be
Valet
128-6619
1 of 10
YOUR " CODE HOPPING " TRANSMITTERS
The transmitters included with your new security system use the most advanced and
secure form of radio frequency transmission available on any current automotive security
system. Some of today’s sophisticated auto thieves use a device known as a code grabber,
which will receive and store the signal from your keychain transmitter, and re-transmit at a
later time to disarm your system.
Y our anti code grabbing transmitters will change their signal every time the button is pressed,
so when a thief grabs then re-transmits your signal, the alarm system
If your transmitter button is pressed more than fifty times while it is out of range of the vehicle
(children playing with your keys), the transmitter will not operate when you return to the
vehicle, and will need to be re-aligned to the receiver. To do this, simply press the Lock button
two times within a one second time period. The system will now respond to that transmitter
each time a button is pressed.
ARMING THE SYSTEM - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.
2. Press and release the Lock button on the keychain transmitter.
þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
þ Siren sounds one chirp.
will not
respond.
If the siren/horn sounds 3 chirps, then you have left a door , trunk, or hood
lid ajar. Simply close the opened entry point to provide full protection. If
the siren "chirped" three times, sometime after arming, the exclusive
delayed dome light learn circuit has been programmed and the system
detected a open entry point after the learned delay expired. Again, closing the hood, trunk, or doors will correct the problem and you do not need
to disarm the system to make the correction. If the siren/horn did not
sound when arming, then the chirps have been turned off and you should
refer to the section titled "ELIMINATING THE ARM/DISARM CHIRPS" in
this manual.
o Vehicles horn beeps one time.
If the horn beeps three times, then you have left a door, trunk, or hood lid ajar .
Simply close the opened entry point to provide full protection. If the horn did
not sound when arming, then the chirps have been turned off, and you
should refer to the section titled " ELIMINATING THE ARM / DISARM CHIRPS "
in this manual.
o Doors Lock - Optional
o Headlight Illumination - Optional
The vehicle’s headlights turn on for approximately 30 seconds, illuminating
the path as you leave the vehicle.
SILENT ARMING - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.
2. Press and hold the Lock button on the keychain transmitter for 2 seconds.
þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
Page 2
128-6619
2 of 10
þ Siren will not sound.
If the siren "chirped" three times, sometime after arming, the exclusive
delayed dome light learn circuit has been programmed and the system
detected a open entry point after the learned delay expired. Closing the
hood, trunk, or doors will correct the problem and you do not need to
disarm the system to make the correction.
o Vehicles horn will not beep.
If the horn beeps three times, then you have left a door, trunk, or hood lid ajar .
Simply close the opened entry point to provide full protection.
o Doors Lock - Optional
o Headlight Illumination - Optional
The vehicle’s headlights turn on for approximately 30 seconds, illuminating the
path as you leave the vehicle.
ARMING THE SYSTEM - PASSIVE ( AUTOMATIC )
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood lid, and trunk lid.
2. Opening any protected entry point during the 30 second passive arming cycle will immedi-
þ Red dash mounted LED begins to flash rapidly, indicating 30 second passive
arming has begun.
ately suspend automatic arming, and the 30 second passive arming cycle will re-start
when all doors are closed. At the end of the passive arming cycle;
þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
þ Siren sounds one chirp
If the siren did not sound when arming, then the chirps have been turned off,
and you should refer to the section titled "ELIMINATING THE ARM / DISARM
CHIRPS" in this manual.
o Vehicles horn beeps one time.
If the horn did not sound when arming, then the chirps have been turned off,
and you should refer to the section titled "ELIMINATING THE ARM / DISARM
CHIRPS" in this manual.
o Doors Lock - Optional
Door locking during passive arming is a selectable feature. The alarm can be
programmed to allow the doors to lock only when arming using the keychain
transmitter, and they will not automatically lock during passive arming.
PROTECTION WHILE THE SYSTEM IS ARMED
þ Opening any protected door, hood, or trunk lid will cause the alarm to immediately
sound. The alarm will continue to sound for 30 seconds, then stop and continue to
monitor all protected entry points. If the thief left a door opened, the alarm will sound
for six 30 second cycles, remain armed, and ignore that triggered zone.
þ Whenever the system is armed, the red dash mounted LED indicator will slowly flash.
This serves as a visual deterrent to the potential thief. The LED is a very low current
bulb, and will not cause the vehicle’s battery to drain, even when left unattended for
extended periods.
þ Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30
second alarm cycle, attracting visual attention to the vehicle.
Page 3
128-6619
3 of 10
Loading...