Audiovox PRO-9642a Owner's Manual
Model PRO-9642a
Owner's Manual
3 Button Remote Security System
FEATURES:
2 Three Button Programmable RF Transmitters
Three Channel Receiver (capable of accepting 4 transmitters)
Code Hopping Technology
Remote Panic in all modes
Protected Valet
7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
Instant Siren Activation
Low Current Horn Output
Starter Disable
True Last Door Arming (hardwire only)
Defective Zone By-Pass
Hardwire or Voltage Sense Selectable
Active or Passive Arming Selectable
Programmable Auto Lock On / Off
Programmable Auto Unlock On / Off
Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
Programmable Active or Passive Door Locks
User Programmable Permanent Chirp Delete
On Command RF Chirp Delete from Transmitter
6 Tone Multi-Tone Siren
RF Inhibit with ignition on
Parking Light Flasher
OPTIONS:
Single or Dual Stage Shock Sensor
Remote Trunk Release
Remote Keyless Entry
Multiple Vehicle Capable
Remote Starter
Remote Power Window Roll Up
Remote Garage Door Interface
From 9642a with new transmitters & PBLED 5/07
Page 1
128-8179
1 of 8
NOTE: Y our system has the option of using a siren, the vehicle horn, or both for the sounding
device. Where the siren is referenced below, the horn or both may in fact chirp, or
beep.
ARMING THE SYSTEM - ACTIVE
1. Turn off the engine, exit the vehicle and close all doors, hood lid, and trunk lid.
2. Press and release the Arm / Lock button on the keychain transmitter .
SILENT ARMING - ACTIVE
1. Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid.
2. Press and hold the Arm / Lock button on the keychain transmitter for 2 seconds.
ARMING THE SYSTEM - P ASSIVE ( AUTOMATIC )
1. Turn off the engine, exit the vehicle and close and lock all doors, hood lid, and trunk lid.
2. Opening any protected entry point during the 30 second passive arming cycle will
; Red dash mounted LED begins to flash slowly .
; Parking Lights flash one time.
; Siren and / or Horn sounds one chirp.
If the siren/horn
ajar. Simply close the opened entry point to provide full protection. If the siren
"chirped" three times, sometime after arming, the exclusive delayed dome light
learn circuit has been programmed and the system detected a open entry point
after the learned delay expired. Again, closing the hood, trunk, or doors will
correct the problem and you do not need to disarm the system to make the
correction. If the siren/horn did not sound when arming, then the chirps have
been turned off, and you should refer to the section titled “ ELIMINA TING THE
ARM / DISARM CHIRPS “ in this manual.
Doors Lock - Optional
; Red dash mounted LED begins to flash slowly .
; Parking Lights flash one time.
; Siren/Horn will not sound.
If the siren/horn sounds 3 chirps, then you have left a door, trunk, or the
hood lid ajar. Simply close the opened entry point to provide full protection.
Doors Lock - Optional
; Red dash mounted LED begins to flash rapidly , indicating 30 second passive
arming has begun.
immediately suspend automatic arming and the 30 second passive arming cycle will
re-start when all doors are closed. At the end of the passive arming cycle;
; Red dash mounted LED begins to flash slowly .
; Parking Lights flash one time.
; Siren and or Horn sounds one chirp
If the siren/horn did not sound when arming, then the chirps have been
turned off and you should refer to the section titled "ELIMINA TING THE
ARM / DISARM CHIRPS" in this manual.
Doors Lock - Optional
Door locking during passive arming is a selectable feature. The alarm can
be programmed to allow the doors to lock only when arming using the
keychain transmitter and they will not automatically lock during passive arming.
sounds 3 chirp s, then you have left a door , trunk, or hood lid
Page 2
128-8179
2 of 8
PROTECTION WHILE THE SYSTEM IS ARMED
; Opening any protected door, hood, or trunk lid will cause the alarm to immediately
sound. The alarm will continue to sound for 30 seconds, then stop and continue to
monitor all protected entry points. If the thief left a door opened, the alarm will sound for
six 30 second cycles, remain armed and ignore that triggered zone.
; Whenever the system is armed, the red dash mounted LED indicator will slowly flash.
This serves as a visual deterrent to the potential thief. The LED is a very low current
bulb and will not cause the vehicle’s battery to drain, even when left unattended for
extended periods.
; Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30
second alarm cycle, attracting visual attention to the vehicle.
Optional - Whenever the system is armed, the vehicle’s starting circuit will be by-
passed. If the thief should choose to ignore the siren/horn, the vehicle can not be
started.
Optional - Any strong impact to the vehicle will cause the alarm to trigger for the full 30
second alarm cycle.
Optional - Any mild impact to the vehicle will cause the alarm to sound a short series of
warning tones.
DISARMING THE SYSTEM
1. As you approach the vehicle, press and release the Disarm / Unlock button on the keychain
transmitter.
; Red dash mounted LED turns off.
; Parking Lights flash two times.
; Siren / Horn sounds two chirps.
Doors Unlock - Optional
If passive arming was selected during the installation, then the LED will
start flashing rapidly , indicating that the system is re-arming automatically.
Open any door to suspend the automatic arming.
If the parking lights flashed three times, then the alarm was triggered in
your absence. Before turning the key on, examine the LED to identify
which zone was triggered.
If the siren/horn sounds 4 chirps, then the alarm was triggered in your
absence. Before turning the key on, examine the LED and refer to the
INTRUSION WARNING SIGNALS section of this manual to identify which
zone was triggered.
If the siren/horn did not sound when disarming, then the chirps have
been turned off, and you should refer to the section titled "ELIMINA TING
THE ARM / DISARM CHIRPS" in this manual.
SILENT DISARMING
1. As you approach the vehicle, press and hold the Disarm / Unlock button on the keychain
transmitter for 2 seconds.
; Red dash mounted LED turns off.
; Parking Lights flash two times.
If passive arming was selected during the installation, then the LED will
start flashing rapidly , indicating that the system is re-arming automatically.
Open any door to suspend the automatic arming.
Page 3
128-8179
3 of 8
Loading...