Audiovox PRO-9642 User Manual

Model PRO-9642

Owner's Manual

3 Button Remote Security System

FEATURES:

w 2 Three Button Programmable RF Transmitters
w Three Channel Receiver (capable of accepting 4 transmitters)
w Anti-scan Technology
w Remote Panic in all modes
w Protected Valet
w 7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
w Intrusion Alert with Memory
w Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w Instant Siren Activation
w Low Current Horn Output
w True Last Door Arming (hardwire only)
w Defective Zone By-Pass
w Hardwire or Voltage Sense Selectable
w Active or Passive Arming Selectable
w Programmable Auto Lock On / Off
w Programmable Auto Unlock On / Off
w Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
w Programmable Active or Passive Door Locks
w User Programmable Permanent Chirp Delete
w On Command RF Chirp Delete from Transmitter
w 6 Tone Multi-Tone Siren
w RF Inhibit with ignition on
w Parking Light Flasher

OPTIONS:

w Single or Dual Stage Shock Sensor
w Starter Disable
w Remote Trunk Release
w Remote Keyless Entry
w Multiple Vehicle Capable
w Remote Starter
w Remote Power Window Roll Up
w Remote Garage Door Interface

ARMING THE SYSTEM - ACTIVE

1. Turn off the engine, exit the vehicle and close all doors, hood lid, and trunk lid.

2. Press and release the Arm / Lock button on the keychain transmitter.

þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
þ Siren and / or Horn sounds one chirp.

If the siren sounds 3 chirps, then you have left a door, trunk, or the hood
lid ajar. Simply close the opened entry point to provide full protection. If the
siren/horn did not sound when arming, then the chirps have been turned
off and you should refer to the section titled "ELIMINATING THE ARM /
DISARM CHIRPS" in this manual.

o Doors Lock - Optional

SILENT ARMING - ACTIVE

1. Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid.

2. Press and hold the Arm / Lock button on the keychain transmitter for 2 seconds.

þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
þ Siren/Horn will not sound.

If the siren/horn sounds 3 chirps, then you have left a door, trunk, or the
hood lid ajar. Simply close the opened entry point to provide full protection.

o Doors Lock - Optional

ARMING THE SYSTEM - PASSIVE ( AUT OMATIC )

1. Turn off the engine, exit the vehicle and close and lock all doors, hood lid, and trunk lid.
þ Red dash mounted LED begins to flash rapidly, indicating 30 second passive

arming has begun.

2. Opening any protected entry point during the 30 second passive arming cycle will

immediately suspend automatic arming and the 30 second passive arming cycle will
re- star t when all doors are closed. At the end of the passive arming cycle;

þ Red dash mounted LED begins to flash slowly.
þ Parking Lights flash one time.
þ Siren and or Horn sounds one chirp

If the siren/horn did not sound when arming, then the chirps have been
turned off and you should refer to the section titled "ELIMINATING THE
ARM / DISARM CHIRPS" in this manual.

o Doors Lock - Optional

Door locking during passive arming is a selectable feature. The alarm can
be programmed to allow the doors to lock only when arming using the
keychain transmitter and they will not aut oma tic ally lock during passive arming.

PROTECTION WHILE THE SYSTEM IS ARMED

þ Opening any protected door, hood, or trunk lid will cause the alarm to immediately sound.

The alarm will continue to sound for 30 seconds, then stop and continue to monitor all

Page 2

protected entry points. If the thief left a door opened, the alarm will sound for six 30
second cycles, remain armed and ignore that triggered zone.

þ Whenever the system is armed, the red dash mounted LED indicator will slowly flash.

This serves as a visual deterrent to the potential thief. The LED is a very low current
bulb and will not cause the vehicle’s battery to drain, even when left unattended for
extended periods.

þ Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30

second alarm cycle, attracting visual attention to the vehicle.

o Optional - Whenever the system is armed, the vehicle’s starting circuit will be bypassed.

If the thief should choose to ignore the siren/horn, the vehicle can not be started.

o Optional - Any strong impact to the vehicle will cause the alarm to trigger for the full 30

second alarm cycle.

o Optional - Any mild impact to the vehicle will cause the alarm to sound a short series of

warning tones.

DISARMING THE SYSTEM

1. As you approach the vehicle, press and release the Disarm / Unlock button on the keychain

transmitter.

þ Red dash mounted LED turns off.

If passive arming was selected during the installation, then the LED will
start flashing rapidly, indicating that the system is re-arming automatically.
Open any door to suspend the automatic arming.

þ Parking Lights flash two times.

If the parking lights flashed three times, then the alarm was triggered in
your absence. Before turning the key on, examine the LED to identify which
zone was triggered.

þ Siren / Horn sounds two chirps.

If the siren/horn sounds 4 chirps, then the alarm was triggered in your
absence. Before turning the key on, examine the LED and refer to the
INTRUSION WARNING SIGNALS section of this manual to identify which
zone was triggered.
If the siren/horn did not sound when disarming, then the chirps have been
turned off, and you should refer to the section titled "ELIMINATING THE
ARM / DISARM CHIRPS" in this manual.

o Doors Unlock - Optional

SILENT DISARMING

1. As you approach the vehicle, press and hold the Disarm / Unlock button on the keychain

transmitter for 2 seconds.

þ Red dash mounted LED turns off.

If passive arming was selected during the installation, then the LED will
start flashing rapidly, indicating that the system is re-arming automatically.
Open any door to suspend the automatic arming.

Page 3