Audiovox PRO-9276C User Manual

Model PRO-9276C

Owner’s Manual

7 Channel Remote Car Starter

FEA TURES :

 2 Five Button Programmable RF Transmitters
 Seven Channel Receiver (capable of accepting 4 transmitters)
 Code Hopping Technology

 External SuperheterodyneReceiver Antenna w/PushButton Switch &

LED

 Safe Start RF Control (Double Push Of RF Transmitter)
 Selectable Automatic Timed Start Mode
 ( + ) and ( - ) Keyless Entry Outputs
 On-Board Start Relay
 On-Board Accessory Relay
 3 On-Board Ignition Relays
 On-Board Parking Light Relay
 Ignition 2 & 3 Relay Selectable On or Off During Cranking
 Ground Output While Running / Shock By-Pass / GM VAT Output

(relay required)

 Tach Signal Learning Circuit
 Two ( + ) and Two ( - ) Safety Shutdown Circuits
 Alarm By-Pass Output
 Channel 3 Output for Remote Trunk Release (relay required)
 Channel 4, 5, 6, & 7 Output to Control Optional Accessories
 Selectable Steady or Flashing Parking Lights for Run Indication
 Selectable Run Times
 Selectable Door Lock Output Pulse Timing
 Optional Illuminated Entry Output (Relay Required)
 Vehicle Horn Activation Output For R/S Annunciation
 External Activation Control Input
 Turbo Timer Mode

OPTIONS:

 Telematic Upgrade Ready
 Plug In Flash Logic By-Pass Capable
 Remote Power Window Control
 Remote Garage Door Interface
 Multiple Vehicle Capable

WARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle

starting device. A running engine produces dangerous carbon monoxide fumes
which can be harmful or fatal if prolonged exposure occurs. DO NOT remote
start the vehicle if the car is garaged.

Page 1

128-8785

1 of 8

YOUR "CODE HOPPING" TRANSMITTERS

to the receiver. To do this, simply press the lock/unlock button two times within a one
second time period. The system will now respond to that transmitter each time a button is
pressed.
For reference the transmitter packaged with your system may not appear exactly as
shown below. This depiction is for reference only.
NOTE: As an option, this system has the ability to operate the vehicles horn which may
require some additional parts. If this feature is installed, the vehicle's horn will beep once
when you lock the doors, twice when you unlock the doors, twice when the Remote Start
feature is activated, and will beep during the car finder mode to allow you to find the
vehicle more easily in a crowded parking lot.

KEYLESS ENTRY

1. To lock your vehicle, exit the vehicle, close all doors, hood and trunk, then simply press
the lock button of your keychain transmitter. To unlock your vehicle, simply press the
unlock button of your keychain transmitter. As a keyless entry unit, for your convenience,
the parking lights will flash once when the doors are locked and twice when the door are
unlocked. If the optional illuminated entry feature has been added, the interior light will turn
on when the doors are unlocked and remain on for 30 seconds or until the ignition is turned
on.
Holding the lock/unlock transmitter button for 3 seconds will activate the car finder mode
causing the parking lights to flash and the optional horn to beep for 30 seconds or until the
button is activated again for 3 seconds or any other button is operated.
NOTE: This system has the ability to unlock the drivers door with the first press of the

Additionally this system can be programmed to automatically lock and unlock the doors
with the turning on and off of the ignition key.

ADDITIONAL REMOTE FUNCTION (CHANNEL 3)

This system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are:

The transmitters included with your new remote start system use the most
advanced and secure form of radio frequency transmission available on
any current automotive remote system. Some of today’s sophisticated
auto thieves use a device known as a code grabber, which will receive
and store the signal from your keychain transmitter and re-transmit at a
later time to unlock your system.
Your code hopping transmitters will change their signal every time the
button is pressed, so when a thief grabs then re-transmits your signal, the
system will not respond.
If your transmitter button is pressed more than fifty times while it is out of
range of the vehicle (children playing with your keys), the transmitter will
not operate when you return to the vehicle, and will need to be re-aligned

unlock transmitter button and then unlock all other doors when the unlock button is
pressed a second time. This optional feature may require additional components.
Consult your installation center to determine if this feature has been added to your
vehicle.

Remote Trunk Release
 Remote Window Closure
Remote Garage Door Interface

Page 2

128-8785

2 of 8

To activate the optional accessory, press and hold the trunk/key button on the keychain
transmitter for four seconds.

NOTE: The feature that has been added to channel 3 will always be activated using the

ADDITIONAL REMOTE FUNCTION (CHANNEL 4)

This system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are:

To activate the optional accessory, press the option button on the keychain transmitter.
The optional accessory will immediately engage.

ADDITIONAL REMOTE FUNCTION (CHANNEL 5)

This system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are:

To activate the optional accessory, press the option button on the keychain transmitter.
The optional accessory will immediately engage.

ADDITIONAL REMOTE FUNCTION (CHANNEL 6)

This system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are:

To activate the optional accessory, press the option button on the keychain transmitter.
The optional accessory will immediately engage.

same transmitter button that remotely starts the vehicle. There is no way to
move the channel 3 function to a different transmitter button.

 Can Be Set Up To Activate Rear Window Defogger During Remote
Start If Vehicle Is So Equipped

 Remote Window Closure
 Rear Hatch Release
 Right Or Left Slider Doors in An Equipped Van

 Remote Trunk Release
 Remote Window Closure
 Rear Hatch Release
 Right Or Left Slider Doors in An Equipped Van

 Rear Hatch Release
 Right Or Left Slider Doors in An Equipped Van
 Driver Priority Settings In Vehicles So Equipped

ADDITIONAL REMOTE FUNCTION (CHANNEL 7)

This system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are:

To activate the optional accessory, press the option button on the keychain transmitter.
The optional accessory will immediately engage.
NOTE: If your system utilizes the transmitter shown, the second option button may

be configured to operate additional accessories. Please consult your
installing retailer for more information concerning the options available.

 Rear Hatch Release
 Right Or Left Slider Doors in An Equipped Van
 Driver Priority Settings In Vehicles So Equipped
 Second Driver Priority Settings In Vehicles So Equipped

Page 3

128-8785

3 of 8