Audiovox PRO-9175FT4 User Manual

Model PRO-9175FT4

Owner’s Manual

4 Channel Remote

Car Starter

FEA TURES :

w 2 Four Button Programmable RF Transmitters
w Seperate Lock And Unlock Transmitter Buttons
w Four Channel Receiver
w Anti Code Grabbing Technology
w Remote Start Safety Control Switch
w Safe Start RF Control (Double Push Of RF Transmitter)
w Selectable Automatic Timed Start Mode
w Negative and Positive Keyless Entry Outputs
w On-Board Start Relay
w On-Board Accessory Relay
w On-Board Ignition 1 Relay
w On-Board Ignition 2 Relay
w On-Board Parking Light Relay
w Ignition 2 Relay Selectable On or Off During Cranking
w Ignition 3 / Shock By-Pass / GM V AT Output (relay required)
w Tach Signal Learning Circuit
w Two Negative and Two Positive Safety Shutdown Circuits
w Alarm By-Pass Output
w Channel 3 Output for Remote Trunk Release (relay required)
w Channel 4 Output to Control Optional Accessories
w Selectable Steady or Flashing Parking Lights for Run Indication
w Selectable 5, 10, 15 or 20 Minute Run Time
w Selectable 1 Sec. 3.5 Sec. Or Double Pulse Door Lock Output
w Optional Illuminated Entry Output (Relay Required)
w External Activation Control Input

OPTIONS:

w Remote Power Window Control
w Remote Garage Door Interface
w Multiple Vehicle Capable

CAUTION! Be certain that the vehicle is outdoors before using this or any remote

vehicle starting device. A running engine produces dangerous carbon
monoxide fumes which can be harmful or fatal if prolonged exposure
occurs. DO NOT remote start the vehicle if it is garaged.

(capable of accepting 4 transmitters)

YOUR “ ANTI -CODE GRABBING “ TRANSMITTERS

The transmitters included with your new remote start system use the most advanced and
secure form of radio frequency transmission available on any current automotive remote
system. Some of today’s sophisticated auto thieves use a device known as a code grabber,
which will receive and store the signal from your keychain transmitter, and re-transmit at a
later time to unlock your system.
Y our anti-code grabbing transmitters will change their signal every time the button is pressed,
so when a thief grabs then re-transmits your signal, the system
If your transmitter button is pressed more than fifty times while it is out of range of the
vehicle ( children playing with your keys ), the transmitter will not operate when you return
to the vehicle, and will need to be re-aligned to the receiver. To do this, simply press the
Lock button two times within a one second time period. The system will now respond to that
transmitter each time a button is pressed.
For reference the transmitter packaged with your PRO-9175FT4 is shown below.

KEYLESS ENTRY

1. To lock or unlock the doors simply press and release the transmitter
button with the Lock or Unlock symbol. As a keyless entry unit, for your
convenience, the parking lights will flash once when the doors are locked
and twice when the door are unlocked. If the optional illuminated entry
feature has been added, the interior light will turn on when the doors are
unlocked and remain on for 30 seconds or until the ignition is turned on.
Holding the lock or unlock transmitter button for 3 seconds will activate
the car finder mode causing the parking lights to flash for 30 seconds or
until the button is activated again for 3 seconds or anyother button is
operated.

NOTE: This system has the ability to unlock the drivers door with the first press of the

unlock transmitter button and then unlock all other doors when the unlock button is
pressed a second time. This optioanl feature may require additional components.
Consult your installation center to determine if this feature has been added to your
vehicle.

ADDITIONAL (OPTIONAL) REMOTE FUNCTION (CHANNEL 3)

This system has an additional feature that can be connected to a number of different op­tional accessories. Some of the more common uses for this channel are;

o Remote Trunk Release
o Remote Window Closure
o Remote Garage Door Interface

T o activate the optional accessory , press and hold the transmitter button with the T runk/Key
symbol on it for 4 seconds.
NOTE: The feature that has been added to channel 3 will always be activated using the

same transmitter button that remotely starts the vehicle. There is no way to move
the channel 3 function to a different transmitter button.

ADDITIONAL (OPTIONAL) REMOTE FUNCTION ( CHANNEL 4 )

This system has an additional feature that can be connected to a number of different op­tional accessories. Some of the more common uses for this channel are;

o Remote Trunk Release
o Remote Window Closure
o Remote Garage Door Interface

Page 2

will not

respond.