Audiovox OE3B Users Manual

PRO-OE3B

THREE-BUTTON TRANSMITTER

The PRO-OE3B transmitter is a replacement RF transmitter. The transmitter
comes with 3 push-button switches.

1). Press LEFT push-button switch on control first receiver ( Your alarm
system ).

2). Press RIGHT push-button switch to control second receiver ( It can be an
alarm system or electric device ).

3). Press DOWN push-button switch to control third receiver ( It can be an
alarm system or electric device ).

TRANSMITTER BATTERY REPLACEMENT

If the range of your transmitter deteriorate, it is possible that you need to
replace the battery.

1). Release the screw from the back of transmitter and remove upper
transmitter case.

2). Remove old battery from transmitter.

3). Install a new battery (12 volt) noting the (+) and (-) marks in the battery
area of the transmitter.

4). Replace upper transmitter case with area, don’t damage the inside
components.

5). Tighten the screw on the back of transmitter.

This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference

that may cause undesired operation.