Audiovox OD70 S, OD70, OD70 P User Manual

ELECTRONICS CORP .

PROV916/

ON OFF AUTO

H E A D P H O N E S

VOD705

PROV916 S/

PROV916 P

DVD PLAYER

AUTO

CHANNEL SOURCE VOLUMEFMSELECT

PROG

R I D U A

T U P N I

EO ID V

DROP-DOWN

WITH

VIDEO

TV/MONITOR

128-6745

DATE : 21/05/03

1 of 31

Important Notice

It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a screen that is located in the motor vehicle at any point forward of the back of the driver’s seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. In the interest of safety, the PROV916/PROV916 S/PROV916 P should never be installed where it will be visible, directly or indirectly, by the operator of the motor vehicle.

Warnings

Do not use any solvents or cleaning materials when cleaning the video monitor. Do not use any abrasive cleaners, they may scratch the screen. Use only a lightly dampened lint free cloth to wipe the screen if it is dirty. Lock the LCD screen in the fully closed position when not in use. Before putting on headphones always adjust the volume setting to the lowest position. Remember to leave the dome light switch in the off or auto positions when the vehicle is unattended, as the dome lights, if left on, can drain the vehicle’s battery. Do not put pressure on the screen.

Television Reception

This entertainment system is designed primarily for viewing prerecorded movies or playing video games. Television reception in a moving vehicle will be limited and in some areas will not be possible due to weak and variable signal strength. Television viewing in a stationary vehicle will result in an improvement, but may still be marginal due to signal strength. The quality of the picture will not be consistent with home TV reception. Reception may be affected by weather and distance from TV station. A weak signal may cause the picture to roll, be snowy, or cause some color loss.

-2-

128-6745

2 of 31

Features

Congratulations on your purchase of the Audiovox PROV916/PROV916 S/PROV916 P DVD Player with Drop-Down Video TV/Monitor. The PROV916/ PROV916 S/PROV916 P has been designed to give you and your family many years of video entertainment in the mobile environment. Please read the directions that follow to familiarize yourself with the product and to ensure that you obtain the best results from your equipment. Please note: Installation options vary, see the individual owner’s manuals for each component in your system to obtain a full understanding of each component’s operation.

Safety Precaution

For safety reasons, when changing video media it is recommended that the vehicle is not in motion, and that you do not allow children to unfasten seat-belts to change video media or make any adjustments to the system. System adjustments can be accomplished using the remote control unit, while seat-belts remain fastened. Enjoy your Audiovox entertainment system but remember-safety of all passengers remains the number one priority.

• 9 Inch TFT (Thin Film Transistor) Active Matrix

LCD (Liquid Crystal Display) Monitor

• OSD (On Screen Display) for Control of Picture

Quality and Functions

• Built-in TV Tuner

• Full Function Remote Control

• Six Frequency FM Modulator with remote

control and OSD

• Dual Channel Infrared Transmitter for IR

Wireless Headphones (Satellite Radio Ready)

• Two Audio / Video Inputs

• Headphone / Speaker Amplifier

• Two Headphone Jacks

• Forward and Side Remote Sensor

• Dome Lights with Switch

• Backlit Controls for Low Light Operation

• Last Position Memory for DVD

-3-

128-6745

3 of 31

Controls and Indicators Diagram

ON OFF AUTO

H E A

D P H O N E S

891011121314151617181921

2 3

POWER

EJECT

PLAY

STOP

AUTO

CHANNEL SOURCE VOLUMEFMSELECT

PROG

R IO D U A

T U P N I

O E D I V

-4-

128-6745

4 of 31

Main Function Descriptions

1. DVD Disc insertion slot – For loading Disc.

2. POWER Button – Bright red when system is on dim when

off.

3. EJECT ( ) Button – For ejecting discs from the disc compartment.

4. PLAY ( ) Button – This button is used to enter the play mode.

5. STOP ( ) Button – To stop playing.

6. Infrared Transmitter and Sensor – Use to transmit audio

to wireless headphones. Also allows the remote control to operate the PROV916/PROV916 S/PROV916 P and to control other accessories in the system.

7. PROV916/PROV916 S/PROV916 P Ventilation Opening.

8. Dome Lights – Provide additional interior illumination.

9. SOURCE Select – Used to select one of the four sources

(TV,AV1, AUX, DVD).

10. CHANNEL ( ) Button – Use this button to decrease the channel number to the desired number. Note : When TV

function is selected.

11. AUTO PROGRAM Button – Allows the user to scan and store active TV stations into memory.

12. CHANNEL( )Button – Use this button to increase the channel number to the desired number. Note : When TV

function is selected.

13. Auxiliary Audio Right Input.

14. Auxiliary Audio Left Input.

15. Auxiliary Video Input.

16. Side Remote Sensor Eye – Allows the remote control to

operate the PROV916/PROV916 S/PROV916 P, control volume to wired headphone jacks and control the other accessories.

17. Drop Down LCD Panel.

18. Headphone Jack – Allow the use of wired headphones

with a 1/8” plug for listening to video program audio.

19. Screen release – Moves in direction of the arrow to release the drop down screen.

20. VOLUME ( ) Button – Use this button to raise the volume level of the headphone jacks. It is also used to make picture adjustments in picture select mode. Note : Audiovox

recommends the use of the Audiovox HP275 Headphones when using wired headphones.

-5-

128-6745

5 of 31

21. FM Select Button – Each time this button is pressed will switched FMM cycles through (FM OFF – POD AUDIO – SAT AUDIO) and the frequency of the channel of modulator will remain same.

22. VOLUME ( ) Button – Use this button to decrease the volume level of the headphone jacks. It is also used to make picture adjustments in picture select mode.

Note:These buttons will not affect the volume of wireless

headphones or the wired RF modulator. When using these devices the volume must be adjusted with the wireless headphone volume control or with your radio’s volume control (see page 15, Wireless Headphones, or page 16, Wired FM Modulator).

23. Three position Dome Light Switch

• Auto – Automatically switches on the dome lights in

conjunction with the vehicle’s interior illumination.

• Off – The dome lights will not turn on in this position.

• On – Turns on the dome lights.

-6-

128-6745

6 of 31

Remote Control Operation

SETUP

Enter

ERASE/

141517

MUTE

REPEAT

1618192021222324252628293031353433

EJECT

Battery Installation

Before attempting to operate your Remote Control, install the batteries as described below.

1) Turn the Remote Control face down. Using a fingernail, lift the battery cover off.

2) Install two “AAA” batteries as shown. Make sure that proper polarity (+ or -) is observed.

3) Align the cover tabs with the remote control and press down until the cover clicks.

The remote control will operate the PROV916/ PROV916 S/PROV916 P and most Audiovox VCP’s. It is not a universal remote control and will not control equipment from other manufacturers. If a universal remote control is to be used with the PROV916/PROV916 S/PROV916 P , choose the remote encoding scheme for Audiovox Televisions when programming the remote control.

POWER

7 8 9

SOURCE

AUTO

MEMORY

SKIP/

WRITE

RETURN

– +

VOL

PIX

-7-

128-6745

7 of 31

DVD Function Descriptions

*Function control is available on the unit and the remote control.

1. POWER Button*

Press this button to turn the PROV916/PROV916 S/PROV916 P on. Press the button again to turn the PROV916/

PROV916 S/PROV916 P off.

2. SOURCE Button*

Video signals from video equipment connected to the audio / video inputs can be displayed on the monitor by pressing this button. Each time the button is pressed, the audio / video source will change the sources: DVD, TV, AV1 and AUX.

3. AUTO MEMORY Button (AUTO PROGRAM Button)*

When the AUTO MEMORY button is pressed, all channels are searched and channels that are detected with signals of sufficent levels are automatically stored.

4. SKIP/SEARCH Button

This button selects betweeen SKIP and SEARCH mode. In “SKIP mode” the TV tuner will tune and stop on channels that are programmed into memory when CHANNEL UP/DOWN buttons are used. When the SKIP mode is disable, the TV will stop on all active channels.

5. ERASE/WRITE Button

While tuned to a channel, pressing this button will store or erase the channel from memory. The stored channel numbers are displayed in “GREEN” on the LCD display screen, and the non-stored channel numbers are in “RED”.

-8-

128-6745

8 of 31

6. Channel Up ( ) Button*

Use this button to increase the channel number to the desired channel and to scroll upward in menu options.

7. MUTE Button

Press this button to mute the audio. Pressing the button again restores sound to the previously set level.

8. ENTER Button

Used to implement setting selected.

9. LEFT ( ) Button

Allows the user to shift left in the menu options.

10. MENU Button

Allows the user to access the main menu.

11. RETURN Button

Allows the user to return to the menu while PBC on.

Note: This function only present on VCD2.0.

12. TV Mode Select Button

Switches certain function keys on the remote control for TV functions.

-9-

128-6745

9 of 31

13. DISPLAY Button

Press to display DVD Disc current information.

Press DISPLAY button DVD Player Perform

Once Display current TITLE & CHAPTER Twice Display current SUBTITLE 3 times Display current AUDIO language & channel

4 times Display current ANGLE 5 times Display A-B current status 6 times Display REPEAT current status 7 times Display is turn off

For Title & Chapter, use cursor buttons to do title/chapter selection, then press Enter button to implement the selection.

For Subtitle, Audio, Angle, A to B & Repeat, press Enter key repeatedly to change the options. These options may vary from disc to disc.

14. PAUSE ( ) Button* Allows the user to pause the playback.

15. PREVIOUS ( ) Button

Allows the user to return to the previous chapter or track.

16. NEXT ( ) Button

Allows the user to skip to the next chapter or track.

-10-

128-6745

10 of 31

+ 21 hidden pages