Audiovox MMSV58 User Manual

MMSV58

5.8" LCD SUN VISOR MONITOR

WITH MIRROR AND DOME LIGHT

Installation Guide

0

Notice

An LCD display and/or video monitor may be installed in a motor vehicle and visible to the driver
if the LCD display or video monitor is used for vehicle information, system control, rear or side
observation or navigation. If the LCD display or video monitor is used for television reception,
video or DVD play, the LCD display or video monitor must be installed so that these features will
only function when the vehicle is in ‘park’ or when the vehicle’s parking brake is applied.

An LCD display or video monitor used for television reception, video or DVD play that operates
when the vehicle is in gear or when the parking brake is not applied, must be installed to the rear
of the driver’s seat where it will not be visible, directly or indirectly, to the operator of the motor
vehicle.

Warnings

♦

Keep the LCD display clean and dry.

♦ Do not use any solvents or cleaning materials when cleaning the LCD display.
♦ Do not use any abrasive cleaners, they may scratch the LCD display. Use only a lightly

dampened lint free cloth to wipe the LCD display if it is dirty.

♦ Remember to leave the dome light switch in the off positions when the vehicle is unattended,

as the dome lights, if left on, can drain the vehicle’s battery.

♦ Do not apply pressure to the LCD display.
♦ Caution children to avoid touching or scratching the LCD display, as it may become dirty or

damaged.

♦ This product is designed to operate with a 12 volt, negative ground battery system.
♦ Do not operate the monitor at temperatures below 32°F (0°C) or above 104°F (40°C).
♦ Do not expose to direct sunlight for extended periods of time.
♦ Never attempt your own repairs. This unit should be installed and repaired by qualified

technicians or service personnel.

♦ Use proper insulation material to prevent short-circuiting of the supply system.

1

MATERIALS INCLUDED IN THIS PACKAGE:





1) MMSV58 Sun Visor Video Monitor (P/N 136-3781) (1 pc)

2) Monitor Mounting Shroud (P/N 1024053) (1pc)

3) Remote Control (P/N 136-B3696) (1pc)

4) Hardware Package:-

• M2.5 x # 8” Screws (4 pcs)

• Rubber Screw Plug Caps ((138-1324) (4 pcs)

5) 7 Pin Power Wire Harness (P/N1123455) (1 pc)





OOLS REQUIRED:

T

Rotary Tool

Phillips Screwdriver
Utility or Razor Knife or S
Wire Strippers
Upholstery hook too
Electrical Tape

Masking Tape
Multimeter (to verify
Fine Point Marker – to mark visor
Misc. electrical connectors (to co

vehicle.

hears

l (for removal of panels as necessary)

12 volt DC and continuity: Do not use a test light or logic probe)



GROUND ACTIVATED

nnect to vehicle power source). Requirements will vary from vehicle to

2